Algorithms and simulators comprised of SPICE3 as a circuit level simulator and two device simulators EOFLOW and PROPHET for accurate simulation of new types of devices are presented in this thesis. An integration of EOFLOW with SPICE3 creates a capability for efficient simulation of a system containing interconnected electroosmotic flow...
A scalable macromodel for substrate noise coupling in lightly doped substrates with and without a buried layer has been developed. This model is based on Z-parameters and is scalable with contact size and separation. This model requires process dependent parameters that can be extracted easily from a small number of...
An analysis that accounts for the effect of standard electrostatic discharge (ESD) structures on critical LNA specifications of noise figure, input matching and gain is presented. It is shown that the ESD structures degrade LNA performance particularly for higher frequency applications. Two LNAs, one with ESD protection and one without,...
This thesis presents distinctly different methods of accurately predicting phase noise and absolute jitter in ring oscillators. The phase noise prediction methods are the commercially available SpectreRF and isf_tool, a simulator developed in this work from the Hajimiri and Lee theory of phase noise. Absolute jitter due to deterministic supply...
In this thesis, the performance degradation of a phase-locked loop due to substrate noise is examined. A new analytical equivalent circuit model for substrate noise coupling is derived for a heavily doped silicon substrate. The model has been validated with measured data from a 0.35 μm CMOS process. Since the...
The dependence of the substrate resistance, R[subscript sub], for MOS transistor RF modeling on transistor biasing and layout is studied from device simulations and measurements. Though R[subscript sub] is found to be bias dependent, the error incurred by assuming a constant value equal to the DC resistance is not significant....
An enhanced swing differential Colpitts VCO (ESDC-VCO) dramatically improves
the swing of a Colpitts VCO by allowing the signal to swing below ground and above the
supply voltage. Fabricated in a 1P8M 0.13 um CMOS process, the ESDC-VCO operates
at 4.9GHz with a 0.475-V supply and consumes 2.7mW. The measured...
In wireless sensor network applications, low-power operation of the wireless receiver is critical. To address this need an ultra-low power Binary Frequency Shift Keying (BFSK) receiver using the super-regenerative architecture is developed.
A prototype receiver is built and tested for operation in the 900 MHz ISM band. Lab measurements show...
This thesis presents an automated methodology to calibrate the substrate profile for accurate prediction of substrate parasitics using Green's function based extractors. The technique requires fabrication of only a few test structures and results in an accurate three layered approximation of a heavily doped epitaxial silicon substrate. The obtained substrate...
This thesis presents Silencer!, a fully automated, schematic-driven tool for substrate noise coupling simulation and analysis. It has been integrated in the CADENCE DFII environment and seamlessly enables substrate coupling analysis in a standard mixed-signal design flow. Silencer! aids IC designers in the analysis of substrate noise coupling at different...
This dissertation focuses on the analysis, design, and application of inductor-capacitor (LC) oscillators for wireless sensor networks (WSNs).
First an analysis and design optimization approach for enhanced swing, low power CMOS LC oscillators is presented. A phasor based analysis is used for determining the amplitude and phase noise of these...
This thesis examines substrate noise coupling for NMOS transistors in heavily doped substrates. The study begins with the analysis of an NMOS transistor switching noise in a digital inverter at the device level. A resistive substrate network for the NMOS transistor is proposed and verified. Coupling between N+- P+ contacts...
A new method is presented to compress switching information in large digital circuits. This is combined with an efficient approach of generating the noise signatures of cells in a digital library that results in an accurate and efficient approach for estimating the noise generated in digital circuits. This method provides...
A fully integrated CMOS GPS receiver RF front end optimized for low power operation is presented. The system operates with a supply voltage down to 250 mV. A prototype has been fabricated in a 0.13μm CMOS process and includes a low voltage LNA, quadrature oscillators, and quadrature mixers. It exhibits...
This thesis presents a comparison of time-domain and frequency-domain algorithms for phase noise calculation in oscillators. Floquet theory provides the mathematical foundation for these calculations and the numerical methods employ perturbation projection vectors (PPVs). The PPVs are an estimate of an oscillator's sensitivity to noise.
The in-house circuit simulator SPICE3...
The continued scaling of deep-submicron CMOS technology enables low-voltage high-frequency phase-locked loops (PLLs) to be fully integrated in complex mixed-signal systems. However, fluctuations due to the manufacturing process and variations in
environmental conditions, such as supply voltage and temperature, are also significantly increased. As a result, the performance of PLLs...
The design of mobile wireless devices has always focused on reducing power, area, and cost. This dissertation proposes two techniques that are leveraged to save power and area and therefore cost. The first techniques reduces the noise in the receiver and results in a relaxed power requirement. The second technique...
A Z-parameter based macromodel for characterizing the substrate noise coupling in a lightly doped substrate at low frequencies has been developed. The model is scalable with contact geometries and separation. The cross-coupling impedance between two contacts is modeled using an improved geometric mean distance formulation. This approach obviates the need...
Circuits operating outside the earth’s atmosphere are more vulnerable to cosmic radiation and require special design consideration. The purpose of this work is to explore methods of mitigating the effect of radiation in phase locked loop (PLL) circuits. Several voltage controlled oscillators (VCOs) and two complete PLLs are designed and...
This thesis presents a low power DC-DC converter suitable for harvesting energy from high impedance thermoelectric generators (TEGs) for the use in body powered electronics. The chip has been fabricated in a 130nm CMOS technology. To meet the power demands of body powered networks, a novel dual-path architecture capable of...