In recent years, there has been an extensive effort to develop low-cost implementations
of radio frequency integrated circuits for consumer applications. This thesis is a
research effort in the design and implementation of integrated RF CMOS Power Amplifiers
(PAs). A significant challenge in the implementation of RF CMOS ICs is...
The demand for portable electronic systems and the continued
down-scaling of device dimensions resulted in rapid improvement in
the performance of integrated systems. Several low-voltage design
techniques have been proposed to operate analog circuits with sub-1V
supply. However, these techniques require higher power consumption
to achieve large dynamic range while...
Nowadays, needs for wideband and high accuracy analog-to-digital converter are increasing rapidly in manifold applications such as wireless communication, digital video and other consumer electronics. Besides, low power consumption is required to have longer battery life in portable systems. CMOS technology scaling and innovative modulator topology make the implementation much...
All-digital PLLs promise flexible and precise frequency modulation continous-wave(FMCW) radar signal signal for 77GHz radar applications. Such PLLs require digitally-controlled oscillators(DCO) with wide frequency tuning range and high resolution to address a range of applications and low phase noise requirements. In this thesis, novel resonator structures with ne capacitance/inductance switching...
As computation power continues to grow, the demand for data transfer bandwidth is also rising. This is reflected in the increasing data-rate of high-speed links. However, the increase in data-rate is sustainable only if the I/O energy efficiency improves as well. This dissertation explores several techniques to enable high-speed links...
Incremental ADCs (IADCs) have many advantages for low-frequency high-accuracy data conversion—they are easy to multiplex between channels, need simpler digital decimation filter, and allow extended counting with a Nyquist-rate ADC. A single-loop incremental ADC was designed and fabricated in 90 nm for a biosensor interface circuit. It incorporates one integrator,...
The increasing popularity of cellular phones with integrated cameras in the
recent past has led to major improvements in its image quality. However, integration of new features, such as mobile email, video streaming, MP3 etc. tend to put the limitation on image quality as camera phone designers struggle to manage...
Digital-to-analog converters (DACs) suffer from static and dynamic nonlinearity problems, which degrade their accuracy and performance. Mismatch errors in the analog components restrict the maximum achievable linearity.
This thesis presents various techniques for correcting these errors. It describes a correction process for the nonlinear behavior of DACs, on three different...
Multiple-input multiple-output (MIMO) antenna technology is promising
for high-speed wireless communications without increasing the transmission band-
width. Space time coding (STC) is a scheme that employs multiple antennas to
increase transmission rate or to improve transmission quality. STC is used widely
in mobile cellular networks, wireless local area networks (WLAN)...
In this thesis work, a design of 14-bit, 20MS/s segmented digital-to-analog converter (DAC) is presented. The segmented DAC uses switched-capacitor configuration to implement 8 (LSB) + 6 (MSB) segmented architecture to achieve high performance for minimum area. The implemented LSB DAC is based on quasi-passive pipelined DAC that has been...