In a homogenous and isotropic material, the location of the neutral axis coincides with the location of the centroid of the beam. Wood is anisotropic, meaning that it has different properties in different directions. It is also non-homogenous, meaning that the beam exhibits different properties at different locations throughout its...
The objective of this research is to use a three-dimensional (3D) analysis
method to include 'system effects' directly in the design of light-frame roof truss
assemblies. The goal of this study is to develop an improved and practical method to
determine the structural performance of 3D roof truss assemblies used...
Torsion test was evaluated as a method to determine the shear strength
parallel to grain of full-size structural composite lumber (SCL). Experimental
results of eighty-five rectangular (44 x 140 mm²) specimens were verified by finite
element analysis. Laminated strand lumber (LSL), laminated veneer lumber
(LVL) and parallel strand lumber (PSL)...
Five different test methods to determine the parallel-to-grain shear
strength of Douglas-fir structural lumber were compared. Four methods
assessed the shear strength of lumber sections having a full nominal two by
four inch cross-section. These were: three-point bending, four-point bending,
five-point bending, and torsion. The fifth method was the ASTM...
In order to describe long term creep behavior of structural lumber in a natural
environment, a bending test with twenty Douglas-Fir beams subjected to a constant
load was set up in an open shed in the Forest Research Laboratory at Oregon State
University. Deflections of the beams were measured along...
For wood beams, it is often assumed that the neutral axis is located at the centroid of the
beam. The neutral axis of isotropic, homogeneous materials is located at the centroid of the
material, but wood is neither isotropic nor homogeneous. The varying grain patterns and
knots located throughout wood...
Current compression perpendicular-to-grain (c-perp) design values for wood members are based on mean stress using the ASTM D143 specimen. Base design value, as determined from 0.04-in deformation in the ASTM specimen, is applied to all c-perp applications. While the standard ASTM test was presumably believed to adequately reflect relevant c-perp...
The overall goal of this project was to design a wood frame shear wall that could withstand greater displacement before damage occurred to the Gypsum Wall Board (GWB). More specifically, the objectives of the study were: (1) to evaluate damage to the GWB in alternative shear wall designs at 1%,...
The objective of this project was to develop an analytical model of a light-framed wood structure using a prevalent structural analysis computer program in order to evaluate system effects and define load paths within the structure, especially under extreme wind events. Simplified modeling techniques and material definitions were developed and...
The goal of this study was to develop an understanding of the nature of surge wave loading on
wood framed residential structures for a variety of building configurations and test conditions.
The objectives of the study were: (1) to measure forces on a 1/6th scale wood framed
residential structure, (2)...
