Index Catalog // ScholarsArchive@OSU

Creator:: Genetti, William Ernest
Resource Type:: Dissertation
Full Text:: than coefficients at the other tube locations. 2. For batch fluidization the average Nusselt number

Creator:: Scott, Bruce Douglas
Abstract:: This paper describes a study of two-phase gas-liquid vertical annular climbing film flow. Using a high speed Fastax movie camera, motion was slowed sufficiently to facilitate detailed analysis of the climbing film structure, based on single frame projections. The dynamic characteristics of the liquid film could likewise be obtained, though...
Resource Type:: Masters Thesis
Full Text:: of this thesis. To my parents for their continuous encouragement. TABLE OF CONTENTS 1. 2

Creator:: Mohandes, Abdolhosein
Abstract:: Friction factors were measured for water flowing in ducts made up of two rods held between two flat plates. Three rod diameters of 0.50, 1.00 and 1.50 inches were used. The spacings between rods varied from 0.0 to 0.32 inch. It was found that the concept of hydraulic diameter was...
Resource Type:: Masters Thesis
Full Text:: points. Analysis of data also showed that 2-8% of the cross-sectional area of duct can be consid- ered

Creator:: Cohn, Paul Daniel
Resource Type:: Masters Thesis
Full Text:: 2 Boiler Oondens~r and Guard Heat er •• ••••• •. 19 Thermocouple Assembly ••••••••••••••••••••• 20

Creator:: Santoso, Elisabeth
Abstract:: The fouling characteristics of cooling tower water containing various corrosion inhibitors and other additives on heat transfer surface have been investigated. Corrosion inhibitors investigated included zinc-chromate and phosphates. In addition, additives including polyacrylate and phosphonate (HEDP and AMP) were used to determine their effectiveness as antifoulants. The tests were conducted...
Resource Type:: Dissertation
Full Text:: LIST OF FIGURES FIGURE PAGE: III-1. Schematic Flow Diagram of Experimental Equipment.18 111-2

Creator:: Roy, Bhasker Vilva
Abstract:: The fouling characteristics of simulated cooling tower water flowing over a heated metallic surface has been studied. The bulk temperature of the water was maintained around 95°F. Mainly three different water qualities with respect to calcium hardness level were investigated. The pH was controlled by the addition of hydrochloric acid....
Resource Type:: Masters Thesis
Full Text:: Fouled condition III-1 Schematic flow diagram of experimental equipment 15 111-2 Heater rod 20 V-1

Creator:: Coates, Kenneth Edwin
Abstract:: Scaling characteristics of calcium carbonate on a heated surface in cooling tower water was investigated. Bulk temperature was maintained constant at 95°F. Flow velocities and surface temperatures ranged from 3 ft/sec to 10.3 ft/sec and from 105°F to 170°F respectively. City water was used as make-up for two different water...
Resource Type:: Masters Thesis
Full Text:: K 294 LIST OF FIGURES Figure 1 Schematic Flow Diagram of Experimental Page Equipment 16 2

ScholarsArchive@OSU