Hand-held devices are among the most successful consumer electronics in modern society. Behind these successful devices, lies a key analog design technique that involves high-performance analog-to-digital conversion combined with very low power consumption. This dissertation presents two different approaches to achieving high power efficiency from a two-step pipelined architecture, which...
This work presents a high-resolution Delta-Sigma ADC which combines the use of the pseudo-pseudo-differential noise filtering technique with single-ended ring amplifier based integrators. The pseudo-pseudo-differential noise filtering technique utilizes single-ended circuits while maintaining the even-order rejection found in fully-differential structures which alleviates, in the active analog blocks, the need for...
Successive-approximation-register (SAR) analog-to-digital converters are popular for medium accuracy, medium speed and low power applications, such as in biomedical applications. They have low latency and simple architecture compared with ΔΣ ADCs. This is because of SAR ADCs’ binary searching scheme. Furthermore, SAR ADCs can apply oversampling and noise shaping schemes...
Low noise oscillators are universally needed in digital systems for clock generation and synchronization, and in radio-frequency communication front-ends for frequency up- and down-conversion. Noise in oscillators results in timing jitter, and limits the clock frequency of digital systems. In radio-frequency communication systems, phase noise in oscillators lowers the signal-to-noise...
This thesis presents a novel algorithmic A/D converter to be used in a biosensor. The converter is capable of a conversion rate of 1.5 bits/phase and hence the required conversion time is reduced. The proposed architecture is analyzed for non-ideal effects and compared with existing algorithmic A/D architectures. The converter...
Evolution of the mobile communication standards and proliferation of hand-held devices mandate stringent Analog-to-Digital Converter (ADC) specifications. Among various ADCs, a ∆Σ ADC is best known as a power-efficient ADC when more than 12b is required. However, a conventional discrete-time (DT) ∆Σ Modulator (∆ΣM) is inadequate for low-power wideband applications...
A digital phase locked loop (DPLL) and a statistical time-to-digital converter (STDC) were previously fabricated in a 0.35µm, 3.3V SOI CMOS process. This work summarizes these designs and characterizes the measured performance. Simulations supplement the measurements where applicable.
The DPLL was found to reach a locked state under a limited...
The design of mixed-signal integrated circuits has evolved from simple analog and digital circuits operating on the same silicon substrate to the point that now we have complete system on a chip solutions for communication systems. The levels of integration needed to remain cost effective in today's integrated circuit (IC)...
Digital-to-analog converters (DACs) with wide dynamic range and high
linearity are required for high-end audio applications. A multi-bit delta sigma
audio DAC, using a novel gain-correction technique, is described in this thesis. For
widely varying on-chip RC time constant, the DAC gain can be accurately
controlled by the correction circuitry....
This thesis presents a continuous time bandpass delta sigma modulator with frequency translation inside the delta sigma loop. The input IF signal is down converted to baseband after amplification by a low Q, wideband bandpass resonator. The down converted IF signal is digitized by a continuous time, second order lowpass...