The dependence of the substrate resistance, R[subscript sub], for MOS transistor RF modeling on transistor biasing and layout is studied from device simulations and measurements. Though R[subscript sub] is found to be bias dependent, the error incurred by assuming a constant value equal to the DC resistance is not significant....
Advancements in power electronics to higher power levels and faster switching times allow new machine and systems designs, but also create higher stresses on electric machinery insulation. High performance, pulse-width modulated (PWM) inverters are now available for medium voltage drive systems, and are being considered by the U.S. Navy as...
The electrical behavior of on-chip interconnects has become a dominant factor in silicon-based high speed, RF, and mixed-signal integrated circuits. In particular, the frequency-dependent loss mechanisms in heavily-doped silicon substrates can have a large influence on the transmission characteristics of on-chip interconnects. To optimize the performance of the integrated circuit,...
This thesis proposes a novel fully digital technique for the estimation and correction of the DAC error in multi-bit delta sigma ADCs. The structure of the DAC error is indicated through a simple model for unit-element based DACs. The impact of the DAC error on the performance of ADC is...
In this thesis, a novel Direct-Charge-Transfer (DCT) integrator structure is proposed, which can settle much faster than regular switch-capacitor integrators. A new Spread-Spectrum Dynamic Element Matching (SS-DEM) algorithm is also introduced, which can effectively spread or shape the nonlinearity error of multi-bit DAC in the feedback path, thus improve the...
Estimating the carrier frequency from a modulated waveform is one of the most important functions of a coherent signal receiver. Good performance and low bit error rates are obtained by coherent demodulation. Therefore, exact knowledge of the received signal carrier frequency is critical for communication systems. Also due to the...
Multi-stage delta-sigma (ΔΣ) architectures, commonly known as MASH, are the preferred choice for analog-to-digital converters (ADCs) used in broadband communication applications, where high-resolution (above 14 bits) and high-bandwidth (several MHz) performances are required. Current state-of-the-art designs are capable of as much as 5-MS/s output data rates with 90-dB SNR. However,...
In some practical systems, most of the errors are of 1 → 0 type and 0 → 1
errors occur very rarely. In this thesis, first, the capacity of the asymmetric
channel is derived. The capacity of the binary symmetric channel (BSC) and the
Z-channel can be derived from this...
This dissertation investigates the use of a hardware mechanism called Eager Data Transfer (EDT) for achieving the reduction of communication latency for user-level network protocol. To reach the goal, the dissertation addresses the following research issues. First, the development of a communication system performance evaluation tool called Linux/SimOS is presented....
With an increasing number of wireless applications at microwave frequencies, the frequency spectrum is becoming quite crowded. Due to this congestion, the current state of technology is leading towards upper microwave and millimeter wave spectra as they also offer other distinct advantages such as larger bandwidth and smaller component footprint....
In Radio Frequency Integrated Circuits (RFIC) or high frequency digital
ICs, there is a demand to probe the internal nodes for testing. The ultra low
capacitance RFIC probe presented in his work is a flexible tool for these
applications. The probe utilizes the coupling between a tungsten needle and the...
A Mobile Ad-hoc NETwork (MANET) is collection of wireless mobile nodes without a network infrastructure or centralized administration. Although MANETs can be used in many applications, such as mobile Internet, military communication, and disaster relief networks, a number of challenges remain. These include routing, medium access control, security, scalability, energy...
With the increasing effort to identify alternative methods of energy generation, extraction of ocean energy has gathered a large interest. Research and industry have begun considering wave energy as the next new alternative energy. The unique challenges of ocean energy requires a wave energy converter to be both robust and...
This work focusses on the modeling and the development of efficient coupled simulation techniques for MEMS based RF oscillators. High-level models for MEMS based varactors have been discussed and their accuracy issues are identified, based on comparisons with numerical simulations. A faster simulation approach based on the time-domain shooting method...
Phase-locked loop (PLL) frequency synthesizers lie at the heart of most radio transceivers. An important objective of the electronics and communications industry is to design high-speed building blocks which dissipate the lowest possible power, and to ac- complish this with the cheapest technology. The dual-modulus prescaler is one of the...
Advanced low power devices promote the development of micro power generators (MPGs) to replace the batteries to power them. Due to the trend in decreasing integrated circuit (IC) supply voltages, power supply designers are facing more and more serious challenges. The objective of this research is to design a power...
Evolution of the mobile communication standards and proliferation of hand-held devices mandate stringent Analog-to-Digital Converter (ADC) specifications. Among various ADCs, a ∆Σ ADC is best known as a power-efficient ADC when more than 12b is required. However, a conventional discrete-time (DT) ∆Σ Modulator (∆ΣM) is inadequate for low-power wideband applications...
An ultra low power crystal oscillator that provides a frequency reference for battery
powered timekeeping applications is presented. An amplitude control circuit is employed to ensure that minimum current is consumed. A subthreshold voltage regulator provides a supply voltage for the oscillator with minimum current consumption. The oscillator and regulator...
Dynamic CMOS circuits are commonly used in high-performance memory arrays to implement wide-NOR logic functions for their read and search operations. This is because dynamic circuits have significantly higher speed and lower area compared to static circuits for performing similar operations. Register File (RF) arrays are located at the top...
The exponential rate of advances in modern communication devices in the last several years have brought us higher levels of functionality and performance as well as reductions in physical size and power consumption. To continue this rate of advancement, next generation systems require wider bandwidth and higher resolution ADCs. Additionally,...
This thesis proposes a novel technique for the design of pipelined and cyclic ADCs utilizing generalized radix gain stages. Several models have been proposed for the optimization of high performance pipelined ADCs by various researchers. This work builds upon them, using a simple but accurate model to estimate the optimal...
An enhanced swing differential Colpitts VCO (ESDC-VCO) dramatically improves
the swing of a Colpitts VCO by allowing the signal to swing below ground and above the
supply voltage. Fabricated in a 1P8M 0.13 um CMOS process, the ESDC-VCO operates
at 4.9GHz with a 0.475-V supply and consumes 2.7mW. The measured...
A fully integrated CMOS GPS receiver RF front end optimized for low power operation is presented. The system operates with a supply voltage down to 250 mV. A prototype has been fabricated in a 0.13μm CMOS process and includes a low voltage LNA, quadrature oscillators, and quadrature mixers. It exhibits...
A two-channel data acquisition system for simultaneous detection and discrimination of beta particles and gamma rays has been developed. Each channel measures and analyzes the input pulses resulting from the absorption of radiation in the layers of the detector. The detector is a triple-layer phoswich (phosphor sandwich) scintillation detector followed...
The Advent of multi-cores allows programs to be executed much faster than before. Cryptoalgorithms use long-bit words thus parallelizing these operations on multi-cores will achieve significant performance improvement. However, not all long-bit word operations in cryptosystems are suitable for parallel execution on multi-cores. In particular, long-bit words used in Elliptic...
Enabled by continued device scaling in CMOS technology, more and more functions that were previously realized in separate chips are getting integrated on a single chip nowadays. Integration on silicon has opened the door to new portable wireless applications, and initiated a widespread use of these devices in our common...
Recently, delta-sigma modulation has become a widely applied technique for high-performance analog-to-digital conversion of narrow-band signals. Most of the early designs used discrete-time structure for good accuracy and good linearity. The transfer functions are independent of the clock frequency. However, high unity-gain bandwidths of the opamps are required to satisfy...
Analog-to-Digital Data Converters (ADCs) used in instrumentation and measurements often require high absolute accuracy, including excellent linearity and negligible dc offset. Incremental data converters (IDCs) provide a solution for such measurement applications. Since IDCs are essentially delta-sigma converters with reset operation before each conversion, they retain most of the advantages...
Multiple-input multiple-output (MIMO) communication systems have recently been considered as one of the most significant technology breakthroughs for modern wireless communications, due to the higher spectral efficiency and improved link reliability. The sphere decoding algorithm (SDA) has been widely used for maximum likelihood (ML) detection in MIMO systems. It is...
The problem of locating a signal source, or an emitter, has many civilian and military applications, such as communication regulations enforcement, military reconnaissance, and search-and-rescue operations. Many of the most widely used emitter location methods rely on the accurate and robust estimation of the differential time delay,
or time-difference-of-arrival (TDOA),...
Nowadays, error correction codes have become an integral part in almost all the modern digital communication and storage systems. With the continuously increasing demands for higher speed and lower power communication systems, efficient VLSI implementations of those error correction codes have great importance for practical applications. In this thesis, several...
Low-Density Parity-check (LDPC) codes have attracted considerable attention due to their capacity approaching performance over AWGN channel and highly parallelizable decoding schemes. They have been considered in a variety of industry standards for the next generation communication systems. In general, LDPC codes achieve outstanding performance with large codeword lengths (e.g.,...
With the growing demand for portable/consumer electronics, such as digital
audio/video (AV), the downscaling of device dimensions, which enables the
integration of an increasing number of transistors in a single chip, is mandatory.
This trend also continuously pushes the power supply voltage down to reduce the
power consumption and improve...
Delay insensitive asynchronous circuitry provides significant advantages with
respect to substrate noise due to localized switching. The differences between the
substrate noise from NULL Convention Logic (NCL) and traditional Clocked
Boolean Logic (CBL) are described and analyzed based on measured results. A test chip fabricated in the TSMC 0.25 um...
This dissertation presents a dual-path 2-0 MASH (Multi-stAge-noise -SHaping) ADC with two verified digital corrections of DAC mismatch error and quantization noise leakage. By using these two techniques, the requirements for the analog circuits are greatly relaxed. The dual-path structure generates two outputs, one only composed of conversion errors, the...
As the functionality of digital chips continues to increase dramatically, chip- to-chip communication bandwidths must scale accordingly to avoid constraining the overall system performance. Therefore, high speed transceiver design has be- come an important research topic. In particular, the performance of the circuits that are responsible for timing accuracy are...
The amount of instruction level parallelism (ILP) that can be exploited depends
greatly on the size of the instruction window and the number of in-flight instructions
the processor can support. However, this requires a register file with a large set of
physical registers for renaming and multiple ports to provide...
Achieving sharpened (enhanced detail) features of a multi-dimensional data source using the linear prediction (LP) bandwidth extrapolation (BWE) technique in the transform domain is the main objective of this research. The evolution of sensor technology has provided acquisition scenarios in which the data format is inherently multi-dimensional, including hyperspectral imaging...
Accurate scaled modeling and simulation are critical to advancing ocean wave linear generator buoys. A 100th scaled model of ocean wave generator buoy systems is analyzed by solving the Navier-Stokes equations. These equations are numerically solved using Computational Fluid Dynamics (CFD) by implementing the front capturing method. In this thesis,...
The demand for portable electronic systems and the continued
down-scaling of device dimensions resulted in rapid improvement in
the performance of integrated systems. Several low-voltage design
techniques have been proposed to operate analog circuits with sub-1V
supply. However, these techniques require higher power consumption
to achieve large dynamic range while...
This thesis presents a channelized digital receiver design for UWB sytems in a multipath indoor environment. The UWB technology has been used for commercial and military purposes due to a number of advantages such as low-power consumption, noise-like and carrier free. The energy of UWB signal is spread over a...
Traditionally linear actuator applications are addressed by the use of hydraulic systems. The high maintenance cost and poor reliability will always be the most critical problem in the real applications. Benefited from both the high mechanical advantage of the roll screw and the simple structure of the switched reluctance motor,...
There is a large and growing market for portable consumer audio products
with very small size. As the size of these products is reduced, the area occupied
by batteries becomes significant and hence limits the number of batteries to one.
In order to build such small products, high levels of...
Recently, continuous-time ΔΣ modulators are appearing increasingly often in both the literature and the marketplace due to their features of inherent antialiasing and relaxed requirements for opamp and so on. However, several nonideal factors such as clock jitter, excess loop delay, inter-symbol interference and so on, degrade the SNR performance...
With the ever-increasing demand for portable devices used in applications
such as wireless communication, mobile computing, consumer electronics, etc.,
the scaling of the CMOS process to deep submicron dimensions becomes more
important to achieve low-cost, low-power and high-performance digital systems.
However, this downscaling also requires similar shrinking of the supply...
Ferrites have been used for various high frequency applications as bulk
materials. These applications, however, are limited to large dimension devices. In
this thesis, thin film ferrites were deposited from a low temperature solution-based
deposition process that is suitable for micro-scale high frequency applications. The
low temperature nature of this...