The dependence of the substrate resistance, R[subscript sub], for MOS transistor RF modeling on transistor biasing and layout is studied from device simulations and measurements. Though R[subscript sub] is found to be bias dependent, the error incurred by assuming a constant value equal to the DC resistance is not significant....
Advancements in power electronics to higher power levels and faster switching times allow new machine and systems designs, but also create higher stresses on electric machinery insulation. High performance, pulse-width modulated (PWM) inverters are now available for medium voltage drive systems, and are being considered by the U.S. Navy as...
The electrical behavior of on-chip interconnects has become a dominant factor in silicon-based high speed, RF, and mixed-signal integrated circuits. In particular, the frequency-dependent loss mechanisms in heavily-doped silicon substrates can have a large influence on the transmission characteristics of on-chip interconnects. To optimize the performance of the integrated circuit,...
This thesis proposes a novel fully digital technique for the estimation and correction of the DAC error in multi-bit delta sigma ADCs. The structure of the DAC error is indicated through a simple model for unit-element based DACs. The impact of the DAC error on the performance of ADC is...
In this thesis, a novel Direct-Charge-Transfer (DCT) integrator structure is proposed, which can settle much faster than regular switch-capacitor integrators. A new Spread-Spectrum Dynamic Element Matching (SS-DEM) algorithm is also introduced, which can effectively spread or shape the nonlinearity error of multi-bit DAC in the feedback path, thus improve the...
Estimating the carrier frequency from a modulated waveform is one of the most important functions of a coherent signal receiver. Good performance and low bit error rates are obtained by coherent demodulation. Therefore, exact knowledge of the received signal carrier frequency is critical for communication systems. Also due to the...
Multi-stage delta-sigma (ΔΣ) architectures, commonly known as MASH, are the preferred choice for analog-to-digital converters (ADCs) used in broadband communication applications, where high-resolution (above 14 bits) and high-bandwidth (several MHz) performances are required. Current state-of-the-art designs are capable of as much as 5-MS/s output data rates with 90-dB SNR. However,...
In some practical systems, most of the errors are of 1 → 0 type and 0 → 1
errors occur very rarely. In this thesis, first, the capacity of the asymmetric
channel is derived. The capacity of the binary symmetric channel (BSC) and the
Z-channel can be derived from this...
This dissertation investigates the use of a hardware mechanism called Eager Data Transfer (EDT) for achieving the reduction of communication latency for user-level network protocol. To reach the goal, the dissertation addresses the following research issues. First, the development of a communication system performance evaluation tool called Linux/SimOS is presented....
With an increasing number of wireless applications at microwave frequencies, the frequency spectrum is becoming quite crowded. Due to this congestion, the current state of technology is leading towards upper microwave and millimeter wave spectra as they also offer other distinct advantages such as larger bandwidth and smaller component footprint....
In Radio Frequency Integrated Circuits (RFIC) or high frequency digital
ICs, there is a demand to probe the internal nodes for testing. The ultra low
capacitance RFIC probe presented in his work is a flexible tool for these
applications. The probe utilizes the coupling between a tungsten needle and the...
A Mobile Ad-hoc NETwork (MANET) is collection of wireless mobile nodes without a network infrastructure or centralized administration. Although MANETs can be used in many applications, such as mobile Internet, military communication, and disaster relief networks, a number of challenges remain. These include routing, medium access control, security, scalability, energy...
With the increasing effort to identify alternative methods of energy generation, extraction of ocean energy has gathered a large interest. Research and industry have begun considering wave energy as the next new alternative energy. The unique challenges of ocean energy requires a wave energy converter to be both robust and...
This work focusses on the modeling and the development of efficient coupled simulation techniques for MEMS based RF oscillators. High-level models for MEMS based varactors have been discussed and their accuracy issues are identified, based on comparisons with numerical simulations. A faster simulation approach based on the time-domain shooting method...
Phase-locked loop (PLL) frequency synthesizers lie at the heart of most radio transceivers. An important objective of the electronics and communications industry is to design high-speed building blocks which dissipate the lowest possible power, and to ac- complish this with the cheapest technology. The dual-modulus prescaler is one of the...
Advanced low power devices promote the development of micro power generators (MPGs) to replace the batteries to power them. Due to the trend in decreasing integrated circuit (IC) supply voltages, power supply designers are facing more and more serious challenges. The objective of this research is to design a power...
Evolution of the mobile communication standards and proliferation of hand-held devices mandate stringent Analog-to-Digital Converter (ADC) specifications. Among various ADCs, a ∆Σ ADC is best known as a power-efficient ADC when more than 12b is required. However, a conventional discrete-time (DT) ∆Σ Modulator (∆ΣM) is inadequate for low-power wideband applications...
An ultra low power crystal oscillator that provides a frequency reference for battery
powered timekeeping applications is presented. An amplitude control circuit is employed to ensure that minimum current is consumed. A subthreshold voltage regulator provides a supply voltage for the oscillator with minimum current consumption. The oscillator and regulator...
Dynamic CMOS circuits are commonly used in high-performance memory arrays to implement wide-NOR logic functions for their read and search operations. This is because dynamic circuits have significantly higher speed and lower area compared to static circuits for performing similar operations. Register File (RF) arrays are located at the top...
The exponential rate of advances in modern communication devices in the last several years have brought us higher levels of functionality and performance as well as reductions in physical size and power consumption. To continue this rate of advancement, next generation systems require wider bandwidth and higher resolution ADCs. Additionally,...