We develop efficient coordination techniques that support inelastic traffic in large-scale distributed dynamic spectrum access DSA networks. By means of any learning algorithm, the proposed techniques enable DSA users to locate and exploit spectrum opportunities effectively, thereby increasing their achieved throughput (or "rewards" to be more general). Basically, learning algorithms...
Phase Locked Loops(PLLs) are an integral part of almost every electronic system. Systems involving low frequency clocks often require PLLs with low bandwidth. The area occupied by the large loop filter capacitor and resistor in a low bandwidth PLL design makes the realization of traditional charge-pump PLL architecture impractical on...
The proliferation of body worn autometric devices has been enabled by advances in low-power electronics and fueled by the quantified-self movement. These devices range in complexity from pedometers to clinical vital sign measurement. They all share the same drawback, typically the most expensive and heaviest component, the battery. The future...
The Focused Ion Beam (FIB) tool is a versatile instrument for nano-machining in
circuit editing. Circuit editing is one of the most important steps in the design of an
electronic circuit on a chip. Circuit editing can be improved by imaging of silicon
plates and analyzing the resultant images. However...
Traditionally, networking protocol designs have placed much emphasis on point-to-point reliability and efficiency. With the recent rise of mobile and multimedia applications, other considerations such as power consumption and/or Quality of Service (QoS) are becoming increasingly important factors in designing network protocols. As such, we present a new flexible framework...
Frequency synthesizers are critical components of all communication systems. This thesis considers the issue of undesirable frequency spurs of a relatively recent type of frequency synthesis architecture called digital-to-time conversion (DTC). The DTC-based frequency synthesis architecture has important performance benefits over older frequency synthesizers, such as fast frequency switching, large...
High Definition video streaming over WLANs faces many challenges because video data requires not only data integrity but also frames have strict playout deadline. Traditional streaming methods that rely solely on either UDP or TCP have difficulties meeting both requirements because UDP incurs packet loss while TCP incurs delay. This...
Ultra-high-speed (>10GS/s), medium-resolution (5~6bit), low-power (<50mW) analog-to-digital converter can find it application in the areas of digital oscilloscopes and next-generation serial link receivers. There are several challenges to enable a successful design, however. First, the time-interleaved architecture is required in order to achieve over 10GS/s sampling rate, with the trade-off...
For the past half century, CMOS process scaling has followed Moore's law, approximately doubling transistor density every 18 months. While locally routed wires have generally scaled with transistor size, longer wires have scaled at a slower rate and in some cases have grown larger as chip size and complexity have...
Radioxenon detection is a technique used to monitor nuclear explosion and verify the Comprehensive Nuclear-Test-Ban Treaty (CTBT). Because of an ultra-low concentration of radioxenon at radioxenon monitoring stations, radioxenon detection systems must have high sensitivity. This sensitivity is measured in terms of detector's minimum detectable concentration (MDC). It is required...
Routing from a single source node to multiple destination nodes using node disjoint paths (NDP) has many important applications in parallel systems. For example, if a source node wants to send distinct messages to distinct destination nodes, then the one-to-many NDP routing is useful.
Unlike parallel systems with shared-memory, each...