Tanoak lumber might supplement the supply of white oak for boat construction, as the tree has extremely thick sapwood that can be pressure- treated readily with preservatives.
One-inch tanoak lumber was kiln -dried to 3 different moisture content ranges, then pressure -treated with water -borne preservatives. Some unseasoned lumber was...
Checking was influenced b drying conditions. This influence was greatest before average moisture content reached 20 per cent, but tension in surface layers caused checking even below this point.
Neither high initial dry-bulb temperature nor initial conditions of high equilibrium moisture content were conducive to checking.
High temperature and high...
Four charges of S-inch paper roll plugs of Oregon maple were kiln-dried at various temperatures and humidities. The charge with the most desirable combination of short drying time and low degrade was dried to 12 per cent moisture content in lit hours, using a dry-bulb temperature of 160 degrees F...
The Oregon Forest Products Laboratory was asked in July 1953 by the Oregon Alder and Maple Company, Willamina, to work on the problem of dark stain which developed at sticker crossings in air-drying red alder (Alnus rubra, Bong.) during the summer months.
Previous experience at the Oregon Alder and Maple...
The vapor-drying process is described briefly and its present status in industry is discussed. Fairly extensive data on the vapor drying of 1-, 2-, and 4-inch Douglas-fir and 2-inch western hemlock lumber are presented. Exploratory work on the vapor drying of redwood, Pacific madrone, red alder and ponderosa pine is...
The increasing volume of young-growth Douglas-fir timber cut in the Pacific Northwest emphasizes the need for more knowledge on the characteristics of lumber sawed from these trees.
The study described here was initiated to learn the extent arid causes of degrade resulting from kiln-drying young-growth Douglas-fir dimension lumber. At the...
Need for increased outlets for common boards led to a study of lalllinated bevel siding.
Low-grade boards of Douglas fir and ponderosa pine were bonded with exterior glue to veneer covering and resin-fiber overlay to form panels subsequently ripped to width and bevel-sawed into siding,
Grooves in the lumber core,...