A method is described to determine the distribution of the bending stresses in a wood beam when some of these stresses exceed the proportional limit. This is used to calculate the position of the neutral axis and the bending strength of some Douglas-fir beams. The calculated values agreed with the...
An anemia of juvenile chinook salmon (Oncorhynchus tshawytscha) is described and stages of development separated by recognizable syndromes. A vitamin E-deficient diet of low rancidity produced a severe microcytic anemia with strong immature red cell response and granulocytosis occurring 2 to 4 weeks before a drop in hemoglobin and hematocrit...
Part I. To aid in the management of the Tillamook Bay commercial salmon fishery, a tagging program was conducted on the salmon and steelhead trout runs in 1953. General migration behavior, the minimum length of time the fish remained in the fishery, population sizes, and fishing mortalities were determined from...
Clatsop Beaches, characterized by flat beach-face slope (1:70) and small sandsize (0.2 mm.), have supported commercial and recreational fisheries for the razor clam (Siliqua patula) for many years. Tracing the linear growth of two year classes through more than one year following set led to a validation of the ring...
The Oregon Fish Commission and Washington Department of Fisheries conducted a cooperative winter steelhead trout (Salmo gairdneri) tagging program on the Columbia River during the winters of 1954-55 and 1955-56. Objectives of the program were: (1) to obtain information on the timing of the various segments of the run; (2)...
ENTOMOLOGISTS, BOTANISTS, and AGRICULTURISTS all
have occasion to concern themselves with bees. The en-tomologist is fascinated by their complex behavior pat-terns, the botanist needs to evaluate their significance infloral biology, and the agriculturist must take them into account as vital factors in crop production. Finally, the apiculturist often wishes to...
This symposium was arranged and conducted in cooperation with the Research and Products Committee of the National Lumber Manufacturers Association, 1319 Eighteenth St., N.W., Washington 6, D.C. The purpose was to bring together a group of approximately 100 individuals broadly representing various phases of the wood industry, the present wood...