Pure aluminum deformed in torsion (shear) at elevated temperatures reaches
a broad "peak" stress and then undergoes about a 17% decrease in flow stress with
deformation to roughly 1-2 equivalent uniaxial strain. Beyond this strain the flow
stress is approximately constant. The sources for this softening are unclear. The
suggested...
The increasing occurrence of aluminosilicate caused complications in krafi pulp mills can be attributed to the closing of purge points and the expanded use of contaminated feedstocks and recycled fiber sources. An active purge of aluminum and silicon from the chemical recovery cycle must be undertaken in order to maintain...
The miniaturization of Microtechnology-based Energy, Chemical and Biological Systems (MECS) is made possible by the use of high aspect ratio microchannel arrays to increase the surface-area-to-volume ratio of the flow conduits within the devices, resulting in an improvement in the heat and mass transfer performance of the devices. However, advantages...
A computational model is developed to study the effects of alumina layer formation on an ablative surface when exposed to high temperature particle laden gas flow. The solidification dynamics i.e., the solid and liquid alumina layer growth rate, and the heat transferred to the ablative surface are investigated. A one-dimensional...
The variegated aqueous chemistries of metal cations are applied to the design and synthesis of non-toxic solution precursors suitable for additive printing of large-area oxide electronics. Polycondensation behaviors of aqueous Al+3 and PO4 +3 are manipulated in the deposition of atomically smooth amorphous aluminum oxide phosphate (AlPO) dielectric films. AlPO...
Many economists believe that the slowdown of the productivity growth rates in the U.S. economy in early 1970's was a consequence of the increased level of environmental regulations. The main reason presented in support of this argument is that increased environmental regulations impose an additional burden to the firms, thus...