In a power system, operators maintain voltage stability through adequate reactive reserves. Maintaining and accessing an efficient allocation of reactive reserves is prohibitively complex because of reactive line losses, the variety of reactive resources, and either limited or variable reactive outputs from renewable sources. By clustering the system into smaller...
The central focus of this thesis is the design, fabrication and characterization of amorphous oxide semiconductor (AOS) thin-film transistor (TFT) current mirrors. The thin-film deposition and circuit fabrication methods used to realize zinc tin oxide (ZTO) TFT
current mirrors are addressed in order to elucidate the processing challenges for this...
The primary objective of this thesis is to develop a process for fabricating integrated circuits based on thin-film transistors (TFTs) using zinc tin oxide (ZTO) as the channel layer. ZTO, in contrast to indium- or gallium-based amorphous oxide semiconductors (AOS), is perceived to be a more commercially viable AOS choice...
The prevalence of Internet-of-Things (IoT) applications leads to an increasing focus on the design and optimization of sensor nodes. Battery lifetime and associated costs of battery replacement often limits the long term operation and viability of sensor nodes. RF wireless energy harvesting on the other hand can be appealing since...
Bird and bat collisions with wind turbines are a problem that needs to be better quantified for its impact to be fully understood. This thesis documents portions of the design of a sensor patch module for use on wind turbines blades to detect impacts caused by birds and bats. This...
This dissertation studies two different wireless microwave sensing applications in the subjects of environmental monitoring and biomedical devices. The environmental sensing application presents a design of novel wireless sensor node configurations. These nodes are intended to be used specifically in a built environment of railroad track ballast for its health...
A wireless power transfer system using inductive coupling was designed and implemented as part of a three-member project team. The system uses coupled magnetic fields at a frequency of 606kHz to transfer electromagnetic energy from a charging base to the batteries of portable devices. It succeeded in transmitting power to...
The number of wind turbines and wind farms in the Pacific Northwest has increased dramatically in the past six years, which represents a significant amount of electrical generation capacity connected to the public electric grid. However, the variable nature of wind sometimes introduces excessive power, or conversely shortages, in power...
Low-distortion architecture is widely used in wideband discrete-time switched-capacitor delta-sigma ADC design. However, it suffers from the power-hungry active adder and critical timing for quantization and dynamic element matching (DEM). To solve this problem, this dissertation presents a delta-sigma modulator architecture with shifted loop delays. In this project, shifted loop...
Nowadays, needs for wideband and high accuracy analog-to-digital converter are increasing rapidly in manifold applications such as wireless communication, digital video and other consumer electronics. Besides, low power consumption is required to have longer battery life in portable systems. CMOS technology scaling and innovative modulator topology make the implementation much...
There is a significant need in recent mobile communication and wireless broadband
systems for high-performance analog-to-digital converters (ADCs) that have wide
bandwidth (BW>5-MHz) and high data rate (>100-Mbps). A delta-sigma ADC is
recognized as a power-efficient ADC architecture when high resolution (>12-b) is
required. This is due to several advantages...
Typical power outputs of commercially available diode lasers are on the
order of 5 milliwatts. This thesis discusses the growth, processing and
fabrication of high power (lOO's of milliwatts) diode lasers. Devices were
grown by Molecular Beam Epitaxy (MBE) and by Metal Organic Chemical
Vapor Deposition (MOCVD). The MOCVD diode...
The Amazon basin is a natural wonder of biodiversity that serves as one of the largest single carbon storage mechanisms in the world. For these reasons, preserving the Amazon and other similar forests is a worthy goal. Protecting these spaces is not possible without understanding the threats facing animal populations...
To protect the environment and save human lives, the detection of various hazardous toxins of biological or chemical origin has been a major challenge to the researchers at Oregon State University. Living fish cells can indicate the presence of a wide range of toxins by reactions such as changing color...
The influence of weather on the long range radio navigation system Loran-C was investigated. The variables analyzed over a period of 255 days were: time differences (TDs), TD signal-to-noise ratios, TD standard deviations (measured at a fixed receiver location in Corvallis, Oregon), time interval numbers (TINOs) (measured at the transmitter...
Efficient time-series analysis can impact multiple application domains such as motif discovery in gene analysis or music data, extracting spectro-temporal patterns in acoustic scene analysis, or annotating and classifying electrical bio-signals (such as ECG, EEG, and EMG) for medical applications.
Time-series analysis involves a variety of tasks.
To predict future...
The purpose of this thesis is to apply the wavelet transform WT to
multiresolution structures for analyzing the information content of images based on
multiresolution signal decomposition of the wavelet representation. The advantage
of the wavelet transform is the fact that it uses different building blocks than the
Fourier's sines...
The awareness of electric power quality has increased over the past decade as electronic equipment
has become more susceptible to power disturbances. The most disruptive power disturbances are voltage
sags and momentary interruptions and their effect on adjustable speed drives (ASDs) is studied in this
thesis.
Several solutions have been...
An important task of a Variable Speed Generation (VSG)
system is the capability to maintain and control the terminal
voltage at some desired value as determined by the
reactive power dispatch strategy.The main objective is to
design a sub-optimal fixed-parameter controller in the
sense that constraints with respect to practical...
Adjustable Speed Drive (ASD) systems are widely used in industry to effectively improve process efficiency and control. Typically, an ASD system consists of a motor with its speed controlled by a power electronics converter via varying the amplitude and frequency of the input voltage. However, several abnormal insulation failures of...
A new structure for the implementation of bit/serial adaptive IIR filter is
presented. The bit level system consists of gated full adders for the arithmetic
unit and data latches for the data path. This approach allows recursive
operation of the IIR filter to be implemented without any global
interconnections, minimal...
The rapid development of semiconductor technology and the increasing complexity of VLSI chips have prompted both the industry and the
academic community alike to take an indepth look at the VLSI design
problem. Many design methodologies have been proposed and associated
computer-aided tools developed. This thesis is a study of...
Pulse Oximetry is a technology used ubiquitously across the medical field for measuring oxygen saturation and heart rate monitoring. In this project a system was developed to use a new technology for pulse oximetry: single-photon avalanche diodes (SPADs). This work outlines the development process and experimental results of a SPAD...
With an increasing number of wireless applications at microwave frequencies, the frequency spectrum is becoming quite crowded. Due to this congestion, the current state of technology is leading towards upper microwave and millimeter wave spectra as they also offer other distinct advantages such as larger bandwidth and smaller component footprint....
In networked control systems (NCS) information or packets usually flow from a
sensor or a set of sensors to a remotely located controller. Then the controller
processes the received information and sends a series of control commands to the
actuators through a communication network which could be either wireless or...
Linear phase variable filters that are obtained with a frequency transformation of the form cos(ω) = P(cos(W)) were analyzed, where P is a finite degree polynomial, ω is the prototype frequency and W is the transformed filter frequency. A new transformation of third order is proposed. The new variable filter...
When the term renewable energy is mentioned in a conversation, wind, solar, and hydro energy typically come to mind. However, there is one major resource that has remained mostly untapped: wave energy. Wind and solar power technologies are well established around the world but they cannot generate electricity all the...
Real time indoor positioning awareness systems aim to add localization capabilities to upcoming wireless technologies that are quickly becoming an important feature for indoor environment. RF-based impulse-radio ultra-wideband (IR-UWB) is a promising technology for in-door positioning systems due to obstacle penetration capabilities, immunity to multi-path and fading, and high resolution....
The electrical output of solar panels is reduced when dust covers the panels, but the air movement produced by a flying drone can be used to remove this debris. This research project will study the effectiveness of a quadcopter drone in dusting a solar panel. A solar panel was covered...
The Brushless Doubly Fed Machine (BDFM) is receiving attention as a candidate for use in adjustable speed drives (ASDs) and variable speed generators (VSGs). With a large percentage of a drive or generator system's cost due to power electronics content, considerable research has been conducted to find drives in which...
Over the last decade, wind penetration in the Pacific Northwest has increased rapidly. The variable nature of this massive new resource has increased stress on the hydropower resource to the point where system limits are currently being reached. In order to cultivate continued growth of the wind energy industry both...
A Mobile Ad-hoc NETwork (MANET) is collection of wireless mobile nodes without a network infrastructure or centralized administration. Although MANETs can be used in many applications, such as mobile Internet, military communication, and disaster relief networks, a number of challenges remain. These include routing, medium access control, security, scalability, energy...
Recent developments in computing technology have generated a demand for more streamlined and effective test systems. By replacing traditional in-chassis wired interconnects with a broadcast wireless system, fault detection and error susceptibility will drastically improve, input/output capabilities will expand, and routing complexity will decrease. Ultra-wideband impulse radio's (UWB-IR) characteristic multipath-immunity...
Impulse-radio ultra-wide-band (IR-UWB) signaling is a promising technique
for high-speed, short-range relay communications networks. Depending on how
the relay node retransmits the signal, there are two main relay schemes: conventional
one-directional (one-way) relay model, and bi-directional (two-way) relay
model. In bi-directional relay communications, wireless network coding (WNC),
also called physical-layer...
This paper proposes a novel means of using analog correlators to improve upon existing Ultra-Wideband receiver architectures. Current architectures aim for an all-digital design for the sake of ease of implementation and conceptual simplicity. This causes some notable design challenges including an ultra-high sampling rate, and difficulty capturing multipath energy....
Indoor localization systems have a variety of applications such as tracking of assets, indoor robot navigation, and monitoring of people (e.g. patients) in hospitals or at home. Global positioning system (GPS) offers location accuracy of several meters and is mainly used for outdoor location-based applications as its accuracy degrades significantly...
As the number of autonomous data collection applications keep increasing, the demand for wireless sensor networks (WSNs) has seen explosive growth. In this dissertation, an ultra-low-energy WSN transmitter is developed to reduce the energy consumption of sensor nodes in WSNs. With an ultra-low-energy transceiver, it is possible to eliminate the...
In wireless sensor network applications, low-power operation of the wireless receiver is critical. To address this need an ultra-low power Binary Frequency Shift Keying (BFSK) receiver using the super-regenerative architecture is developed.
A prototype receiver is built and tested for operation in the 900 MHz ISM band. Lab measurements show...
Low energy design techniques for digital circuits are examined to determine their suitability for use in a digital logic controller for wireless sensor network nodes. Transistor level simulations are used to evaluate the techniques and those demonstrating an energy reduction are used to implement a digital logic controller. The digital...
This thesis presents a low-energy application specific digital controller for a battery-free 2.4 GHz wireless sensor network (WSN) node. The digital controller has been designed and fabricated in a standard 0.13 μm CMOS and implements a simple protocol for WSNs. Techniques such as supply voltage reduction and power gating have...
Silicon photonics has become the most promising platform for future large-scale optical interconnect and optical computing systems due to its inherent CMOS compatibility, which brings exclusive advantages in bandwidth density, energy efficiency, and cost effectiveness. Parallel optical interconnects based on photonic integrated circuits (PICs) have the capacity to meet the...
The major limiting factor of DRAM access time is the low transconductance of the
MOSFET's which have only limited current drive capability. The bipolar junction
transistor(BJT) has a collector current amplification factor, β, times base current and is
limited mostly by the willingness to supply this base current. This collector...
In Radio Frequency Integrated Circuits (RFIC) or high frequency digital
ICs, there is a demand to probe the internal nodes for testing. The ultra low
capacitance RFIC probe presented in his work is a flexible tool for these
applications. The probe utilizes the coupling between a tungsten needle and the...
The low thermal conductivity of gallium arsenide compared to silicon
results in self-heating effects in GaAs MESFETs that limit the electrical
performance of such devices for high power applications. To date, analytical
thermal models of self heating in GaAs MESFETs are based on the assumption
of a uniformly heated channel....
Turbo codes have been used successfully for error correction in digital communications, however, their application to wireless mobile communications is still a fresh research topic. The objective of this thesis is to present a new solution that involves the usage of turbo codes, spatial diversity, and orthogonal complementary codes in...
This thesis focuses on two aspects of transparent electronics, SnO₂ transparent thin-film transistors (TTFTs) and transparent circuits. Both depletion- and enhancement-mode SnO₂ TTFTs are realized. The maximum effective mobility for the depletion- and enhancement-mode devices are 2 cm²V⁻¹s⁻¹ and 0.8 cm²V⁻¹s⁻¹, respectively. A variety of techniques to decrease the carrier...
Hybrid automatic repeat request (HARQ) schemes combine packet retransmission with forward error correction to ensure a reliable communications. In multiple-input multiple output (MIMO) systems, interference cancellation (IC) detection is widely used where the detection and cancellation steps of the simultaneously transmitted data streams occur. In principle, the signal stream estimated...
Increasing threats of terrorism and contraband smuggling have led to a growing interest in millimeter wave/ THz security sensors. Recently, systems combining active and passive sensing into one unit have been proposed where the active mode provides information on range and reflectivity, and the passive mode complements the active by...