Index Catalog // ScholarsArchive@OSU

An evaluation of the cubic autotape under dynamic conditions

Creator:: Plasker, James Robert
Abstract:: Accuracy requirements for positioning a vessel in the near shore area have increased in recent years. To meet these requirements several electronic positioning systems have been developed. One such system is the Cubic Autotape Model DM-40. The Autotape is a circular positioning system which utilizes the phase comparison between transmitted...
Resource Type:: Masters Thesis
Full Text:: Adjustment of Network 16 III. EQUIPMENT 22 Autotape 22 Trigger 26 Velocity Measurements 29 IV. STATIC

The Electrical Equipment of an Ocean-Going Vessel

Creator:: Groves, Del Roy and Barnett, Arthur Rex
Abstract:: The rapid advancement of electrical science has led it to invade the field of marine engineering. On ship-board, all ship's lights, search lights and signal lights are entirely electric. Of power appliances outside of uses on men of war,ship's ventilation is completely electric; electric deck winches and boat cranes are...
Resource Type:: Undergraduate Thesis
Full Text:: equipment of our ship,so in conclusion we will give a brief description of the auxiliary apparatus of

Change in aircraft limiter resistance during blowing and its effect on current division between parallel limiters

Creator:: Oman, Henry
Resource Type:: Masters Thesis
Full Text:: I. Introduction In electric power systems, limiters and fuses are used to protect wires

Design and construction of a constant potential X-ray voltage supply

Creator:: Byers, Cleo Clifford
Resource Type:: Masters Thesis
Full Text:: the rectifier circuits are General Electric KR-6 kenotrons built to operate at a niaximum of 140

Simulation of a high voltage direct current transmission system in an electromagnetic transients program using semiconductor terminals

Creator:: NwaChukwu, David O.
Abstract:: In high voltage direct current(HVDC) systems transmission technology, a.c. power is converted(rectified) to d.c. power by means of a controlled rectifier bridge. This d.c. power is then transmitted through a d.c. link to another converter(inverter) where it is converted back to a.c. power by means of another controlled rectifier bridge....
Resource Type:: Masters Thesis
Full Text:: contains practically all components constituting a power system such as transformers, electric machines

Improved efficiency in medium-power flyback converters

Creator:: Ruttanapaibooncharoen, Surin
Abstract:: Switch-mode power supplies (SMPS's) not only convert energy, they also consume it. Typical operational efficiencies are approximately 25 to 60% for linear power supplies, and approximately 50-90% for switching power supplies. This means that products whose end-use electronics are dc, such as televisions and DVD players, could consume 50% less...
Resource Type:: Masters Thesis
Full Text:: predominantly in ground-based equipment where the generation of heat and low efficiency are not of major

A Microgrid Design Case Study : Synchrophasor Placement and Development of a Protection Laboratory for the Oregon State University - Corvallis Campus

Creator:: Huo, Chen
Abstract:: In the past two years, Oregon State University (OSU) Corvallis campus suffered several power outages. The estimated cost of one of those outages was close to a million dollars worth of equipment and impact on research projects. Meanwhile, the campus grid operates with severely aging power assets. The reliability of...
Resource Type:: Masters Thesis
Full Text:: cost of one of those outages was close to a million dollars worth of equipment and impact on research

Towards reliable and survivable ocean wave energy converters

Creator:: Brown, Adam C.
Abstract:: Ocean wave energy is a new and developing field of renewable energy with great potential. The energy contained in one meter of an average wave off the coast of Newport Oregon could supply dozens of homes with electricity. However, ocean waves are usually quite irregular which leads to large bursts...
Resource Type:: Masters Thesis
Full Text:: defined as, “a property of a system, subsystem, equipment, process, or procedure that provides a

A linear test bed for characterizing the performance of ocean wave energy converters

Creator:: Hogan, Peter M.
Abstract:: Determining the performance characteristics of various ocean wave energy converters (OWEC) has proven to be difficult due to problems replicating a baseline motion profile in the ocean or wave tank to compare these devices. The linear test bed seeks to mechanically simulate the relative linear motion between the active components...
Resource Type:: Masters Thesis
Full Text:: ..............................................................…... 28 2.2 Control System Overview ………………….………………….…... 30 2.3 Equipment Setup in

Evaluation of the performance of a taut-moored dual-body direct-drive waveenergy converter through numerical modeling and physical testing

Creator:: Elwood, David E.
Abstract:: With energy prices rising and increasing concern about the influence of fossil fuels on climate change, wave energy systems are on the verge of commercial implementation. These first generation wave energy converters utilize either pneumatics or hydraulics to convert the mechanical energy of waves into electricity. For the last several...
Resource Type:: Masters Thesis
Full Text:: the vessel is quite large, making it well suited for deploying oceanographic equipment

ScholarsArchive@OSU

An evaluation of the cubic autotape under dynamic conditions

The Electrical Equipment of an Ocean-Going Vessel

Change in aircraft limiter resistance during blowing and its effect on current division between parallel limiters

Design and construction of a constant potential X-ray voltage supply

Simulation of a high voltage direct current transmission system in an electromagnetic transients program using semiconductor terminals

Improved efficiency in medium-power flyback converters

A Microgrid Design Case Study : Synchrophasor Placement and Development of a Protection Laboratory for the Oregon State University - Corvallis Campus

Towards reliable and survivable ocean wave energy converters

A linear test bed for characterizing the performance of ocean wave energy converters

Evaluation of the performance of a taut-moored dual-body direct-drive waveenergy converter through numerical modeling and physical testing

Limit your search

Academic Affiliation

Advisor

Commencement Year

Committee Member

Creator

Date

Decade

Degree Field

Degree Level

Degree Name

File Format

Language

License

Non-Academic Affiliation

Peer Reviewed

Resource Type

Rights Statement

Subject

Search Constraints

Search Results

Limit your search