This thesis investigated the methods of failure in the webs of
built up girders. The beams had rectangular holes five and one-half
inches wide and seven and one-half inches high with rounded corners
in a web fourteen inches deep between flanges. The longitudinal
position of the hole edge varied from...
The miniaturization of energy, chemical and biological systems for distributed and portable applications, known as process intensification, is realized by the enhancement in heat and mass transfer performance within high surface-to-volume ratio microchannels. Fabrication of devices for process intensification is achieved in part by microlamination techniques. These techniques consist of...
Prepreg is widely used in composite manufacturing with advanced composites such as carbon and aramid. The material is characterized by a degree of flexibility (drape) and stickiness (tack), which allows an efficient layup on molds with complex shapes. However, axial instability of compressed fibers during the molding process may occur,...
This study consists of three parts: 1) Part A: Limiting Height Evaluation for
Composite Wall Tests, 2) Part B: Mid-Span Deflection Evaluation for Composite Wall
Tests, and 3) Part C: Nominal Axial Strength Evaluation for Wall-Braced Wall Stud
Columns.
The purpose of Part A is to develop experimentally-based limiting heights...
A significant barrier to the diffusion bonding of large (i.e. 600 mm) microchannel devices is the large capital investment required to setup production. This large capital investment extends from long heating and cooling cycles leading to poor production
capacities. Empirical studies in industry have shown that cooling rate is limited...
The collapse of the I-35W Bridge in Minneapolis, MN on August 1, 2007 brought into question the design and inspection of gusset plates in steel truss bridges. The experimental tests performed in this research study the sway-buckling strength and behavior of large-scale steel gusset plates in an isolated truss connection....