Index Catalog // ScholarsArchive@OSU

High temperature drying : its application to the drying of lumber

Creator:: Forest Products Laboratory (U.S.)
Abstract:: Information reviewed and reaffirmed 1963.
Resource Type:: Technical Report
Full Text:: I FOREST PRODUCTS LABORATORY t FOREST SERVICE . U. S . DEPARTMENT OF

Drying of submerchantable length dimensional lumber

Creator:: Swett, Thomas Michael.
Abstract:: As lumber producers are faced with a diminished and increasingly expensive raw material, the need to maximize resource recovery will increase. Trim-ends (particularly from waned boards) often contain some of the highest quality wood in any given log and lack functionality only in length. This waste, traditionally chipped for pulp,...
Resource Type:: Masters Thesis

Effect of drying on damping and stiffness of nailed joints between wood and plywood

Creator:: Chou, Chun
Abstract:: Wood components, usually assembled in green or semi-dry condition, dry during the initial service life. To evaluate the effect of such drying on joint stiffness and damping, cyclic-load tests were conducted on single-nail joints of wood and plywood that had been exposed to drying cycles. Additional effects studied were the...
Resource Type:: Masters Thesis

The effects of thin kiln sticks on the drying of two inch western hemlock lumber

Creator:: Horton, Robert Kenneth
Abstract:: New technology allows the production of thinner kiln sticks manufactured of phenolic resin impregnated paper which are both structurally and economically realistic. This project tested the effects of kiln stick thicknesses on dry kiln air circulation and on lumber drying degrade. Three variables, stick thickness (3/4, 9/16, 7/16 and 1/4...
Resource Type:: Masters Thesis

Steam-jet heat recovery in a lumber dry kiln

Creator:: Masters, Keith R. W.
Abstract:: Lumber drying accounts for about 70 percent of sawmill energy requirements. Significant recovery of energy used to dry lumber would result in significant energy recovery for the mill. This is desirable because of today's high cost of energy. The objective of this study was to recover some of the energy...
Resource Type:: Masters Thesis

Rheological behavior of Douglas-fir as related to the process of drying

Creator:: Wu, Qinglin
Abstract:: Large inelastic strain occurs inside a piece of lumber during drying. The strain consists of several components such as elastic, plastic, creep, shrinkage and mechano-sorptive effect. The mechanical behavior of the whole board during drying is determined by the behavior of individual strain components and their interactions. Whereas limited investigations...
Resource Type:: Dissertation

Initial study of kiln drying clear Douglas fir planks

Creator:: Stillwell, H. D. and Oregon Forest Products Laboratory
Abstract:: Checking was influenced b drying conditions. This influence was greatest before average moisture content reached 20 per cent, but tension in surface layers caused checking even below this point. Neither high initial dry-bulb temperature nor initial conditions of high equilibrium moisture content were conducive to checking. High temperature and high...
Resource Type:: Technical Report
Full Text:: . M. Dry.ng Stresses in Red Osk.t) Forest Products Journal, Vol. U, No. 1, pp. 71-77. February 19

A method for predicting the drying times for Douglas fir heartwood

Creator:: Nelson, Everald Elmer
Resource Type:: Masters Thesis

How to accomplish rapid kiln drying

Creator:: Forest Products Laboratory (U.S.)
Resource Type:: Technical Report
Full Text:: T E G H N I C A L h I O T E FOREST PRODUCTS LABORATORY. U.5 . FOREST

Killing molds on lumber by steaming

Creator:: Forest Products Laboratory (U.S.)
Resource Type:: Technical Report

ScholarsArchive@OSU

High temperature drying : its application to the drying of lumber

Drying of submerchantable length dimensional lumber

Effect of drying on damping and stiffness of nailed joints between wood and plywood

The effects of thin kiln sticks on the drying of two inch western hemlock lumber

Steam-jet heat recovery in a lumber dry kiln

Rheological behavior of Douglas-fir as related to the process of drying

Initial study of kiln drying clear Douglas fir planks

A method for predicting the drying times for Douglas fir heartwood

How to accomplish rapid kiln drying

Killing molds on lumber by steaming

Limit your search

Academic Affiliation

Advisor

Commencement Year

Committee Member

Conference Name

Creator

Date

Decade

Degree Field

Degree Level

Degree Name

File Format

Language

Non-Academic Affiliation

Peer Reviewed

Resource Type

Rights Statement

Subject

Search Constraints

Search Results

Limit your search