Micro Energy and Chemical Systems (MIECS) are multi-scale microsystems, which rely
on embedded nano and micro-scale features to process bulk amounts of fluid in
applications ranging from man-portable heat pumps, distributed fuel reforming and insitu
waste remediation. Microlamination is a well-known process architecture for
fabricating the highly parallel, high aspect...
Heating, ventilation, and air conditioning systems represent nearly half of building energy usage in the United States. Recent building regulations requiring increased air turnover within buildings will result in even greater air conditioning usage. To alleviate these concerns, membrane-based heat-and-moisture exchangers known as energy recovery ventilators have been developed to...
As the drive continues to reduce the size of Printed Wiring Assemblies (PWAs),
improve performance of electronic assemblies, and reduce costs of these products,
reliable secondary (bottom) side reflow operations must be developed. Attaching Surface
Mount Technology (SMT) components to the secondary side of a Printed Circuit Board
(PCB) is...
Polymer samples of polytetrafluoroethylene (PTFE) and a PTFE-glass weave (RF- 35P) are exposed to low pressure, non-equilibrium glow discharge plasmas for enhanced wettability as measured by static contact angles. Plasma treatments are performed in two parallel plate RF plasma systems, a downstream microwave plasma and a barrel etcher using feed...
Advancing contact angles formed by water and aqueous ethanol solutions were
measured on both bare surfaces and film-covered surfaces of acrylic, glass, hydrophilic
and hydrophobic silicon, polycarbonate, polyester, and stainless steel. Each bare surface
was initially characterized with respect to its hydrophilic - hydrophobic balance. Both
protein films and milk...
Interactions between proteins and contact surfaces can have
important implications in the food industry. Such interactions
contribute to the course of fouling of membrane surfaces and they
appear to mediate bacterial and spore adhesion to some degree as
well. In addition to protein and solution properties, interfacial
behavior is strongly...
The experimental procedure for reactively sputtering
films of silicon nitride together with the methods for
measuring the film thickness have been investigated.
Some of the properties of these nitride films were studied.
These properties included: infrared spectrum,
etching properties, and index of refraction. The adherence
of the films was also...
The thermal contact conductance (TCC) between two machined pieces of stainless steel was studied. A guarded hot plate thermal conductivity test fixture was designed and built for the experiment. Factors investigated included the contact pressure, surface roughness, interface material and average test temperature. The contact pressure at the interface ranged...
Boiling heat transfer is studied for its ability to dissipate high fluxes and achieve heat transfer coefficients two orders of magnitude greater than single-phase heat transfer systems. Heater surface enhancement with increased surface area, varied geometry, wettability contrast and micro/nano-structures can further enhance boiling heat transfer performance through bubble nucleation...
The need for less toxic quantum dots (QDs) has led to a significant number of investigations related to copper indium sulfide (CIS) QDs. Lower toxicity and broad band absorbance width makes CIS QDs appealing for light emitting diodes (LEDs), lasers, sensors, bio-imaging, solar cells, and computing. The optical and electronic...