An automated method, requiring the fabrication of a small set of test structures, efficiently extracts the coefficients of Z-parameter based macromodels. The extraction approach has been validated for both heavily and lightly doped substrates and can be applied to a variety of technologies. After the parameters of a macromodel have...
As advanced wired and wireless communication systems attempt to achieve higher performance, the demand for high resolution and wide signal bandwidth in their associated ADCs is strongly increased. Recently, time-domain quantization has drawn attention from its scalability in deep submicron CMOS processes. Furthermore, there are several interesting aspects of time-domain...
There is a significant need in recent mobile communication and wireless broadband
systems for high-performance analog-to-digital converters (ADCs) that have wide
bandwidth (BW>5-MHz) and high data rate (>100-Mbps). A delta-sigma ADC is
recognized as a power-efficient ADC architecture when high resolution (>12-b) is
required. This is due to several advantages...
Multi-Gigahertz sampling rate Analog-to-Digital Converters (ADC) with 5-8 bits resolution are used in many signal communication applications. Unfortunately, the performance of the high speed ADC is limited by the timing accuracy of the sampling clock. A small sampling uncertainty can cause a large error in the sampled voltage and result...
Magnetically coupled passive transformers are increasingly integrated on-chip for
various analog and radio frequency (RF) applications including direct current
(DC) isolation, impedance transformation/matching, and conversion between
single-ended and differential signals. A primary motivation for the on-chip
integration of transformers is the overall size reduction and reduced cost.
However, the performance...
In this thesis, the performance degradation of a phase-locked loop due to substrate noise is examined. A new analytical equivalent circuit model for substrate noise coupling is derived for a heavily doped silicon substrate. The model has been validated with measured data from a 0.35 μm CMOS process. Since the...
To realize pipelined ADCs in deep-submicron processes, low voltage techniques
must be developed to work around problems created by limited supply voltages such as
the floating switch dead zone, reduced SNR, and reduced OpAmp performance.
This thesis analyzes standard and low voltage design issues for pipelined ADCs
and proposes a...
The continued scaling of deep-submicron CMOS technology enables low-voltage high-frequency phase-locked loops (PLLs) to be fully integrated in complex mixed-signal systems. However, fluctuations due to the manufacturing process and variations in
environmental conditions, such as supply voltage and temperature, are also significantly increased. As a result, the performance of PLLs...
High performance multi-cell delta-sigma modulators are a preferred choice in applications which require programmability. Multi-cell delta-sigma modulators with M unit cells provide 10log10(M) SQNR improvement for the same thermal noise and bias power due to the uncorrelated quantization noises of the M unit ADCs. This concept is used in this...
Modern day CMOS processes are characterized by voltage scaling and geometry scaling. Geometry scaling helps reduce gate delays, thereby aiding in the design of data converters which use time based processing. Another artifact of geometry scaling is the increase in complexity of digital circuitry available on traditional analog ICs, as...
Wireless sensor networks are becoming important in several monitoring and sensing applications. Ultra low power consumption in the sensor nodes is important for extending the battery life of the nodes. In this dissertation, two low power BFSK receiver architectures are proposed and verified with prototype implementations in silicion.
A 2.4...
In an industrial and consumer electronic marketplace that is increasingly demanding greater real-world interactivity in portable and distributed devices, analog to digital converter efficiency and performance is being carefully examined. The successive approximation (SAR) analog to digital converter (ADC) architecture has become popular for its high efficiency at mid-speed and...
A comprehensive and scalable solution for high-performance switched capacitor amplification is presented. Central to this discussion is the concept of ring amplification. A ring amplifier is a small modular amplifier derived from a ring oscillator that naturally embodies all the essential elements of scalability. It can amplify with accurate rail-to-rail...
Delta-sigma analog-to-digital converters traditionally have been used for low speed, high resolution applications such as measurements, sensors, voice and audio systems. Through continued device scaling in CMOS technology and architectural and circuit level design innovations, they have even become popular for wideband, high dynamic range applications such as wired and...
This dissertation presents a low-power high-resolution delta-sigma ADC. Two new architectural design techniques are proposed to reduce the power dissipation of the ADC. Compared to the conventional active adder, the direct charge transfer (DCT) adder greatly saves power by keeping the feedback factor of the active adder unity. However, the...
Hand-held devices are among the most successful consumer electronics in modern society. Behind these successful devices, lies a key analog design technique that involves high-performance analog-to-digital conversion combined with very low power consumption. This dissertation presents two different approaches to achieving high power efficiency from a two-step pipelined architecture, which...
High speed serial links are critical components for addressing the growing demand for I/O bandwidth in next-generation computing applications, such as many-core systems, backplane and optical data communications. Due to continued process scaling and circuit innovations, today's CMOS serial link transceivers can achieve tens of Gb/s per pin. However, most...
As the number of autonomous data collection applications keep increasing, the demand for wireless sensor networks (WSNs) has seen explosive growth. In this dissertation, an ultra-low-energy WSN transmitter is developed to reduce the energy consumption of sensor nodes in WSNs. With an ultra-low-energy transceiver, it is possible to eliminate the...
Short-range wireless communications continually attract interest from both industry and academia, and it is changing our life in every aspect in the last decade. The design of wireless transceivers is the bottleneck for variety applications, due to RF modeling inaccuracy, stringent FCC regulations over the transmitted power spectrum, interference, multi-path...
As CMOS processes keep scaling down devices, the maximum operating frequencies of CMOS devices increase, and hence circuits can process very wide band signals. Moreover, the small physical dimensions of transistors allow the placing of many more blocks into a single chip, including highly accurate analog blocks and complicated digital...
Advances in electronic systems have lead to the demand for high resolution, high bandwidth Analog-to-Digital Converters (ADCs). Oversampled ADCs are well- known for high accuracy applications since they benefit from noise shaping and they usually do not need highly accurate components. However, as a consequence of oversampling, they have limited...
Delta-sigma analog-to-digital converters (ADCs) are suitable for many applications due to several advantages such as relaxed anti-aliasing filter, high signal-to noise and distortion ratio (SNDR) and most important of all, reduced sensitivity to
analog imperfections.This thesis introduces several structures to overcome loop imperfections and stability issues in delta-sigma modulators. First,...
Advances in process technologies have led to the development of low-power high speed digital signal processing blocks that occupy small areas. These advances are critical in the development of portable electronic devices with small feature size and long battery life. However, the design of analog and mixed-signal
building blocks, especially...
This thesis describes circuit architectures and techniques that facilitate the
automatic synthesis and fabrication of analog-to-digital converters (ADCs). Since
automated synthesis already exists for digital circuits and is part of the digital
circuit design flow, this work demonstrates the feasibility of ADC synthesis with
little or no modification to presently...
High speed and high resolution analog-to-digital converter is a key building block for broadband wireless communications, high definition video applications, medical images and so on. By leveraging the down scaling of the latest CMOS technology and the noise shaping properties, delta-sigma (ΔΣ) ADCs are able to achieve wide-band operation and...
This dissertation presents an incremental analog-to-digital converter (ADC) with digital digital-to-analog converter (DAC) mismatch correction. A theoretical time-domain analysis technique was developed to predict the noise performance of the incremental ADC, and a new optimization technique was proposed to minimize the output noise.
In the calibration mode, the incremental ADC...
A duty-cycle controlled switched resistor is a tunable resistive element that uses pulse width modulation as the method of tuning. This thesis will describe the operation of switched resistors and propose several circuit architectures that are well suited to the use of switched resistors. These architectures include filters, mixers, and...
Modern wireless System-on-Chips (SoCs), such as mobile handsets, sensor networks, and mm-wave systems, integrate an entire RF system on a single CMOS chip. Such highly complex systems require significant on-chip digital signal processing to help improve the performance of highly sensitive analog/RF components. The IC
market being competitive, the ability...
Evolution of the mobile communication standards and proliferation of hand-held devices mandate stringent Analog-to-Digital Converter (ADC) specifications. Among various ADCs, a ∆Σ ADC is best known as a power-efficient ADC when more than 12b is required. However, a conventional discrete-time (DT) ∆Σ Modulator (∆ΣM) is inadequate for low-power wideband applications...
Analog-to-digital converters (ADCs) convert analog
continuous time signals into discrete time, digital format. One
precondition that must be met for conventional nyquist rate ADCs is
that the input signal must be suitably band-limited to an input
bandwidth less than the nyquist frequency. This mandates expensive
anti-alias filters which contribute to...
This thesis presents methods to reduce the effects of finite opamp DC gain, output voltage swing limitations in opamps, and component mismatches. The primary contribution of this thesis is a new switched-capacitor method named correlated level shifting (CLS). CLS enables true rail-to-rail operation by storing an estimate of the desired...
Low noise oscillators are universally needed in digital systems for clock generation and synchronization, and in radio-frequency communication front-ends for frequency up- and down-conversion. Noise in oscillators results in timing jitter, and limits the clock frequency of digital systems. In radio-frequency communication systems, phase noise in oscillators lowers the signal-to-noise...
Enabled by continued device scaling in CMOS technology, more and more functions that were previously realized in separate chips are getting integrated on a single chip nowadays. Integration on silicon has opened the door to new portable wireless applications, and initiated a widespread use of these devices in our common...
Delta-Sigma (ΔΣ) analog-to-digital converters (ADCs) are widely used in wireless transceivers. Recently, continuous-time (CT) ΔΣ ADCs gain growing interest in wireless applications for their lower power consumption and wider input bandwidth as compared with the discrete-time (DT) counterparts.
In this thesis, a wideband low-power CT ΔΣ modulator for next generation...
A digital implementation of a PLL has several advantages compared to its
analog counterpart. These include easy scalability with process shrink, elimination
of the noise susceptible analog control for a voltage controlled oscillator (VCO) and
the inherent noise immunity of digital circuits. Several recent digital PLL (DPLL)
implementations have achieved...
Engineering students spend a significant amount of their undergraduate careers focused on technical theory and practice. This intensive student prepares them for their technical challenges in the future. This training is so intense that often the more 'soft skills' such as communication, leadership, design, and troubleshooting are left out or...