A method of locating electric transmission line towers using
ground survey data in a digital computer program is presented in this
thesis. The towers are located for maximum spacing subject to the
constraints of available tower heights, forbidden ground areas, minimum
ground clearance, and specified conductor tensions. The digital
method...
This thesis proposes a criteria for the evaluation of those variable
parameters that influence the response of a hydroelectric generator
driven by a hydraulic turbine of the Kaplan type. It is considered
a requirement that a unit must be stable when supplying an isolated
load and it is assumed that...
The comparative values of impedance and resistance to reactance
ratios are important parameters in determining the load
capacity of an interconnection of power transformer, called a bank.
The full design capabilities of parallel or three-phase connected
transformers cannot be utilized unless the following constraints are
applied.
1. All transformer voltage...
This simulation is a model for a tidal power-peaking plant that
can be used to determine the electrical peaking generation for a given
set of conditions.
The simulation internally contains a tide producing function
for a specific year, the hydraulic characteristics of the plant, and the
plant's machines' characteristics. The...
Measurements
were
made
of the
energy
loss
in
a
superconducting
wire
coil
subjected
to
an
axial
magnetic
field
consisting
of
a
ripple
field
superimposed
on
a
steady
field.
The
loss
was
measured
calorimetrically
using
a
sonic
thermometer
consisting
of
a
resonance tube
filled
with
helium
gas
in
thermal
contact
with...
The three-phase squirrel-cage induction motor is rugged, compact,
inexpensive, can be totally enclosed and requires little maintenance.
Its use as a variable speed drive has been limited, however, by the
state-of-the art of control components.
The advent and continuing development of the silicon controlled
rectifier and associated solid-state components has...
A method is presented for developing a detailed non-linear
voltage regulator system model representation for use in power
system stability studies. This model is implemented within MIMIC,
a digital simulator program, with a particular set of data which
could be taken from field tests. Results are presented from simulations
of...
An instruction set and programming examples are described for
a Distributed Logic Memory computer organization. The computer is
designed to take advantage of the economies of very large-scale circuit
integration. In addition, the computer can grow in an orderly
way. As it grows there is increased parallelism possible so that...
The present thesis is about the electric power distribution system
for the city of Mecca, in Saudi Arabia. The distribution system
of Mecca started suddenly, grew haphazardly and developed quickly
with a load factor as high as 38%. Lack of planning, records and
training plus insufficient experience of management evolved...
The integration of the southern electrical system with the
balance of Thailand has many desirable features, but technical and
economic problems make this a difficult task. It is over 300 miles
between the nearest practical points of the interconnection. In the
next ten years, there will probably be a maximum...
This thesis develops a simulation model for a cumulative connected
compound direct-current generator to varify the operation of
this machine under conditions of slowly and rapidly changing loads.
The application of this simulation method will contribute to
more exact modeling of power system components. The accuracy
gained is in the...
The North American interconnected power systems continuously
attempt to hold power system time as close to standard time as possible.
All inherent problems associated with normal power system
operation make this a difficult task. System time is presently allowed
to deviate from standard time by up to two seconds before...
The purpose of this thesis is to investigate the necessity of
transposition in the construction of overhead transmission lines.
Line currents, line voltages and line losses of both the transposed
and untransposed lines were calculated and compared for two different
voltage classes. The conventional method of symmetrical components
was used...
In this thesis, a digital computer method for locating transmission
line towers is presented. The computer program selects the
position of both angle and tangent type towers for a given ground profile.
This selection will provide a minimum cost per foot of
transmission line in terms of the average costs...
An algorithm for computing the parameter sensitivities of an excitation system for a hydroelectric generation system is developed for model analysis in this thesis. The IEEE Type 1 excitation system representation, linked with a simplified alternator and voltage regulator equivalent, provide a closed-loop model for digital simulation. Parametric sensitivities are...