The
experimental
procedure
for
evaporating
silicon
monoxide
together
with
the
methods
for
measuring
the film
thickness
have
been
investigated.
The
effects
of
various
process
parameters
on
the
rate
of
deposition,
such
as
source
temperature
and
source-substrate
distance,
have
been
studied.
The
uniformity
of
silicon
monoxide
films
deposited
by
this
particular...
A modeling technique for simulating the noise
performance of chopper-stabilized switched-capacitor
filters using SPICE2 is presented. A method for
selection of switched-capacitor network (SCN) stages
to be chopped and an op amp topology for low noise
applications are also outlined. Validity of the
modeling is verified by the close agreement...
This thesis describes design techniques for high-performance switched-capacitor
(SC) circuits, primarily for high-linearity low-noise SC circuits in the presence of
component imperfections, such as nonlinear op-amp voltage transfer characteristics,
capacitor nonlinearities as well as the finite op-amp dc gain and op-amp offset and noise.
Various correlated-double-sampling (CDS) schemes are discussed,...
In this work a new voltage buffer, the drain-follower, achieves 300MHz band-width with 2pF load, a dc gain of 0.993V/V, 1mV offset voltage, -60 dB total harmonic distortion at 1.4Vpp output voltage and 6.5mW power dissipation from 5V supply. A unity-gain buffer switched-capacitor biquad filter has been implemented in 0.5μm...
Electrical energy storage devices are currently the main limiting factor in many electrical devices and with the increasing demands placed on electrical power over fossil fuels, high energy density materials are essential. Previous research by Huang et al. on bulk (1-x)Bi(Zn₁/₂Ti₁/₂)O₃-xABO₃ solid solution systems led to the discovery of an...
A frequency compensation technique for increasing the
settling speed of two-stage operational amplifiers used in
switched-capacitor applications has been developed. By
properly decompressing the pole-zero doublet to form a
three-pole one zero system, the settling speed is increased
up to 50 percent as compared to the optimized two-pole
system.
It has been verified by theoretical analysis, circuit simulation and test that two
switch transistors in parallel in a simple sample and hold circuit can be achieve high speed
with low error voltage due to charge injection. The wide transistor provides low RC time
constant when it is closed and...
Voltage converters or charge pumps find their use in many circuits. They are extensively used in hand held devices as cell phones, pagers, PDA's and laptops. Some of the important issues relating to design of voltage regulators for handheld devices are size, efficiency and noise. Another important factor to be...
A MOS biquadratic (biquad) filter employing the switched-current technique is
reported. The circuit uses current-mode processing which can offer wide
bandwidth, low voltage operation, and can be implemented with standard CMOS
technology. Examples of lowpass, highpass, and bandpass filters are given
which illustrate the synthesis procedures and the versatility of...
Digitally-programmable filters have been an ongoing research topic for a number of years. The first such filters were FIR transversal filters using Charge-Coupled Devices (CCD's) and IIR recursive filters using switched-capacitor (SC) techniques. Although both techniques achieve excellent results, they require non-standard and/or additional IC fabrication steps. Low substrate doping...
Analog computation in the form of neural networks is currently
receiving much attention. Existing algorithms cannot be easily
implemented in hardware because of the large number of neurons needed
and the number of connections necessary between them. These problems
have motivated development of alternatives to a conventional
implementation. Hence, a...
Oversampled delta-sigma modulation is one of the widely used A/D conversion
techniques for narrow bandwidth signals. In this study several new lowpass and
bandpass delta-sigma modulator architectures as well as novel pseudo-N-path integrators
that can be used in implementing these architectures are proposed.
By using multiplexing techniques the new lowpass...
In this thesis, novel design techniques have been proposed for implementing high-linearity SC circuits in a standard digital CMOS process. They use nonlinear MOSFET capacitors instead of linear double-poly capacitors. To reduce their nonlinearities, a bias voltage is applied to keep MOSFET capacitors in their accumulation regions. For further reduction...
Dielectric ceramics designed for capacitor applications for use in extreme environments, such as high temperatures, high voltages, or high-pressure environments, are in great demand. Existing capacitor technology fails to perform within these extreme conditions or such environments. The development of new dielectric ceramic materials for high temperature capacitor applications is...
This thesis describes compensation techniques for cascaded delta-sigma A/D
converters (ADCs) and high-performance switched-capacitor (SC) circuits. Various
correlated-double-sampling (CDS) techniques are presented to reduce the effects of the
nonidealities, such as clock feedthrough, charge injection, opamp input-referred noise and
offset, and finite opamp gain, in SC circuits. A CDS technique...
The design of a switched capacitor successive approximation A/D converter is discussed in this thesis. This design adopts a novel capacitance mismatch error cancellation algorithm proposed in references [25, 27]. Detailed charge domain analysis is given in this thesis, which results in an improvement of the proposed algorithm by tracing...
Recently, switched capacitor DC/DC converters are extensively used in portable electronic devices because they feature many advantages, such as high efficiency, small package, low quiescent current, minimal external components and low cost. In this thesis, two step-down switched capacitor DC/DC converters are designed. One has the fixed output options 1.5V,...
Pipelined analog to digital converters (ADCs) are very important building blocks in many electronic systems such as high quality video systems, high performance digital communication systems and high speed data acquisition systems. The rapid development of these applications is driving the design of pipeline ADCs towards higher speed, higher dynamic...
Delta-sigma analog-to-digital converters (ADCs) are suitable for many applications due to several advantages such as relaxed anti-aliasing filter, high signal-to noise and distortion ratio (SNDR) and most important of all, reduced sensitivity to
analog imperfections.This thesis introduces several structures to overcome loop imperfections and stability issues in delta-sigma modulators. First,...
The objective of this work is to explore the feasibility of replacing conventional op-amps with inverters in switched-capacitor (SC) circuits. In order to verify the idea, a low-pass filter (LPF) and a second-order delta-sigma (∆Σ) analog-todigital converter (ADC) are designed in the 0.5-m CMOS technology. The low-pass filter structure is...
The design of a 10-bit pipelined charge redistribution DAC employing MOSCAPs biased in their accumulation mode is presented in this thesis. A switched capacitor filter and output buffer have also been designed for the system. The effect of MOSCAP nonlinearity on the performance of the pipelined charge redistribution DAC has...
Data converters are essential interface circuits between the analog world that people live in and the digital processors that people live with. Linearity, which often is a tradeoff against other performance criteria, is one of the major performance demands from applications for both analog-to-digital converts (ADC) and digital-to-analog converters (DAC)....
Permanent magnet synchronous machines (PMSMs) are widely used in electric vehicles and hybrid electric vehicles to propel the wheels. Various control strategies have been developed for PMSM drive systems to achieve both high efficiency and safe operation. In a PMSM drive system, generally the high voltage battery and the power...
High-accuracy and high-speed CMOS track-and-hold (T/H) or sample-and-hold (S/H) circuits are an important part of the analog-to-digital interface. The switched-capacitor (SC) circuits usually contain one or more op-amps whose dc offset, finite gain, finite bandwidth have a big impact on the accuracy of the track-and-hold circuit. Basic correlated double sampling...
In recent years, the rapidly growth of CMOS technology has evolved towards submicron and deep-submicron features. Due to smaller device sizes, and significant demand for low-power designs, the maximum allowable power supply voltage is restricted. So far, two solutions; clock boosting and switched opamp schemes have been proposed. The material...
A comprehensive and scalable solution for high-performance switched capacitor amplification is presented. Central to this discussion is the concept of ring amplification. A ring amplifier is a small modular amplifier derived from a ring oscillator that naturally embodies all the essential elements of scalability. It can amplify with accurate rail-to-rail...
Switched-capacitor (SC) circuits are commonly used for analog signal processing because they can be used to realize precision filters and data converters on an integrated circuit (IC). However, for high speed applications SC circuit operating speeds are limited by the internally-compensated opamps found in SC integrators, a common building block...
To realize pipelined ADCs in deep-submicron processes, low voltage techniques
must be developed to work around problems created by limited supply voltages such as
the floating switch dead zone, reduced SNR, and reduced OpAmp performance.
This thesis analyzes standard and low voltage design issues for pipelined ADCs
and proposes a...
The aim of this research is to develop a fundamental understanding of the dominant defect species and the relevant defect equilibrium conditions for bismuth-containing perovskites to help guide the development of these materials for emerging applications. This is of paramount importance for many demanding applications, because ultimately the defect equilibria...
The most accurate method for performing analog signal processing in MOS (metal-oxide-semiconductor) integrated circuits is through the use of switched-capacitor circuits. A switched-capacitor circuit operates as a discrete-time signal processor. These circuits have been used in a variety of applications, such as filters, gain stages, voltage-controlled oscillators, and modulators. A...
This dissertation presents a low-power high-resolution delta-sigma ADC. Two new architectural design techniques are proposed to reduce the power dissipation of the ADC. Compared to the conventional active adder, the direct charge transfer (DCT) adder greatly saves power by keeping the feedback factor of the active adder unity. However, the...
Analog-to-digital converters (ADCs) convert analog
continuous time signals into discrete time, digital format. One
precondition that must be met for conventional nyquist rate ADCs is
that the input signal must be suitably band-limited to an input
bandwidth less than the nyquist frequency. This mandates expensive
anti-alias filters which contribute to...