The optical transition in high-fraction polymorphs of titania (TiO2) were investigated to determine the band gap behavior of the most common polymorphs—brookite, rutile, and anatase—the values of which are varied in the literature. The direct optical band gaps of brookite, rutile, and anatase, were determined to be 3.37(7)eV, 3.41(11)eV and...
Transparent conductive oxides (TCOs), primarily indium doped tin oxide, have been widely used in numerous fields since decades ago, such as solar cells, displays, OLEDs and ‘smart windows’ etc. Owing to the scarcity of indium, there is a great demand for new alternative materials. Metal/insulator/metal (MIM) diodes are a critical...
Polylactic acid (PLA), a renewable material, is used widely in a variety of commercial and specialty applications. However, certain limitations such as high temperature stability and brittleness limit its applicability. This problem is addressed by reinforcing PLA with a variety of materials but the process gives rise to different issues...
The structural and stress changes in molybdenum/amorphous silicon (Mo/a-Si)
EUV reflecting multilayers during annealing at 316°C were studied. The amorphous
interlayers, with an Mo:Si stoichiometry of 1:2, grew during annealing. The residual
stresses in each component of the multilayer also changed significantly. Through high
resolution electron microscopy, selected area electron...
CuGaSe₂/CuInSe₂ tandem junction solar cell is currently being pursued to be a low cost and high efficiency renewable energy source. A reported theoretical efficiency of 33.9% solar cells has been the motivation to fabricate CuGaSe₂ films in a simple and low cost method. Electrodeposition is a potentially suitable method to...
The objective of this thesis is to provide an initial demonstration of the feasibility of constructing highly transparent active electronic devices. Such a demonstration is successfully achieved in the fabrication of ZnO-based thin film transistors (TFTs) exhibiting transparency greater than ~90% in the visible portion of the electromagnetic spectrum and...
....................................................... 5
2.2 Thinfilm electrical and optical properties of p-type transparent con-
ductors. Et denotes
The code is developed for the calculation of the magneto-crystalline anisotropy (MAE) in thin films using a classical Heisenberg hamiltonian with a correction developed by Van Vleck. A Metropolis style Monte Carlo algorithm was used with adequate corrections to accelerate the calculation. The MAE was calculated for the case of...
We have performed fluorescence extended X-ray absorption fine structure (EXAFS) measurements on the Cd K-edge of partial electrolyte (PE) treated Cu(In[subscript 0.7]Ga[subscript 0.3])Se₂ (CIGS) thin film samples using synchrotron X-ray radiation. This data was compared to the EXAFS spectra of CdSe and CdO standards. Cd local structure models were constructed...