The merits of the photoelastic coating technique as applied to
wood were evaluated. Comparative tests were made on 12 nominal
two-by-four Douglas Fir boards. The object of these tests was to
determine the limitations of this technique, such as accuracy and
complexity of experimental procedure. Correlation of the experimental
results...
A study of stress transfer near the ends of the whisker in a simulated whisker reinforced composite material was conducted by using
photoelastic techniques. The composite material studied was
αAl₂O₃ whiskers in an aluminum matrix. The photoelastic models
used consisted of a scaled-up macroscopic stiffener embedded in a
three-dimensional epoxy...
The stress concentration factors at butt joints in six-ply laminated
lumber were determined experimentally. Concentration factors
for a uniform tensile stress were found for a joint at each of
three possible locations.
Four experimental techniques were used and evaluated on actual
wood specimens: strain gages, brittle lacquer, moiré grids, and...
In the construction of a cab-over-engine semi tractor, Freightliner
Corporation of Portland, Oregon uses brackets to make the connection
between the front leaf spring mounts, bumper, front hinges
for the tilt-cab and the longitudinal frame rails. One bracket is used
on each side. The integrity of these brackets is essential...
Dead weight creep tests were conducted on polycarbonate in
order to determine if it is a linear viscoelastic material; or if it is
not, then to determine the feasibility of photoplastic stress freezing.
Secondary objectives were: the determination of the parameters in the
creep compliance of a four element viscoelastic...
A numerical technique is presented for solving the gas dynamics
of a pulsating combustor. The computer solution which is developed
follows directly from the fundamental conservation laws applied to
discrete volumes rather than attempting either to finite difference the
resulting partial differential equations, or to apply the Method of Characteristics....
Design considerations are presented which apply to all types of
electrical resistance strain gage transducers. While the concepts
apply to mass produced transducers, the information should be most
useful for the engineer or technician who designs one-of-a-kind or
"home-made" transducers.
Errors which affect the accuracy of strain gage transducers are...
The determination of failure is complicated when a structural
element is subjected to combined rather than simple stresses. This
is especially true when the principle of superposition does not apply.
For such cases, tests of the element under the expected loads are
required to determine its failure criteria.
In this...
The concept of a prestressed cylindrical shell was investigated. In particular, a cylindrical shell constructed from coiled pressurized tubing was analyzed. This analysis was concentrated in two main areas, the first involved the failure modes of the prestressed cylinder. Both the buckling and yielding behavior of the tube walls was...
This dissertation deals with end and side launching of marine
vessels. Its object is three-fold: first, to review several successful
techniques of launching and to describe the problems involved;
second, to derive and explain the calculations needed for assuring a
successful launching; and third, to propose several computer programs
which...