This study determined the independent effects of various homogenization cycles and
precipitation treatments on the elevated temperature workability and the final ambient
temperature mechanical properties of AA2024 aluminum alloy and on the T3 tensile
properties of 2014 aluminum alloy as well as T6 tensile properties of 2618 and 2618 (Curich)...
Ti-6Al-2Sn-4Zr-2Mo-0.1Si specimens were shaped by repeated cycles of heating
(to 954 °C) and hammer or press forging followed by a solution anneal that varied from
968 to 998 °C. The coupons were originally extracted from billets forged below the beta
trans us ( 1009 °C) and slow cooled to ambient...
Aluminum single crystals were cyclically deformed in single-slip at small strain amplitudes
at 77 K to presaturation. The observed mechanical behavior is consistent with other
recent work. The dislocation substructure was analyzed in detail. The structure can be
described as consisting of dense bundles or veins of dislocation dipoles, separated...
The structural and stress changes in molybdenum/amorphous silicon (Mo/a-Si)
EUV reflecting multilayers during annealing at 316°C were studied. The amorphous
interlayers, with an Mo:Si stoichiometry of 1:2, grew during annealing. The residual
stresses in each component of the multilayer also changed significantly. Through high
resolution electron microscopy, selected area electron...
Part I discusses the development of an aluminum-magnesium-silicon alloy that may combine strength, extrudability, favorable corrosion resistance with low cost and scrap compatibility. The first part of the study determined the effects of small composition, heat treatment and mechanical processing changes on the ambient temperature tensile properties of the alloy....
Zirconium press plates have been developed for the production of melamine coated particle board, using shot-peening to achieve the desired plate (and therefore coated particle board) surface texture. Service temperatures of the press plates approach 200°C. This study examined the microstructural effects of extended exposure of shot-peened zirconium to temperatures...
Dwell time low cycle fatigue (DLCF), low cycle fatigue (LCF), and creep tests were performed at ambient temperature on Ti-6Al-2Sn-4Zr-2Mo-0.1Si (Ti-6242Si). Test specimens were solution annealed at various temperatures below the beta transus to control the volume fraction of primary alpha. The influence of the changes in primary alpha phase...