The deployment of advanced technology standards for 5G and beyond in cellular networks has resulted in interest in integrated circuits (ICs) operating at frequencies above 10GHz. This has sparked research on wideband circuits in commercial low-cost silicon technologies, operating at high RF and mm-wave frequencies. Given the wide range of...
The need for sustainably powering unobtrusive internet-of-things applications has led to an interest in energy harvesting. Particularly, the proliferation of wireless communication and devices in the 2.4 GHz Industrial Scientific c Medical (ISM) band creates an opportunity to leverage commonly used devices for RF powering. This dissertation presents a low-quiescent-power...
This research focuses on receiver architectures which enable better spectral eciency
by handling blockers in the same spectral range as the signal. The presence of
such blockers, without the use of blocker cancelling/ ltering techniques leads to gain
compression and hence, consequent performance degradation of receivers leading to
reduced spectrum...
With the need for higher spectral efficiency and data rates the rise of simultaneous transmit-and-receive (STAR) radios is becoming increasingly valuable. While many systems employ two separate channels for transmit and receive to double the data speed, this comes at the cost of doubling the RF band. This same performance...
Scalable array transceivers with wide frequency tuning range are attractive for next-generationradios. Key challenges for such radios include generation of LO signals with widefrequency tuning range, scalable synchronization between multiple array unit cells andtolerance to in-band and out-of-band interferers. This thesis presents approaches toaddress these challenges in commercial CMOS technologies.The...
The increasing demand for higher data-rates in spectrum-deficient indoor WiFi networks calls for the adaptation of hybrid systems, consisting of RF and optical wireless channels. The novel hybrid WiFi Free-Space Optical (WIFO) system was introduced to enhance the wireless capacity of indoor WiFi networks. In this thesis, an optical wireless...
Wireless localization of objects is useful for several applications that require the knowledge
of position of objects or people. Additionally, power extraction from wireless
signals eliminates the need for wires or any physical connections for charging. This
project is based on system-level testing of an integrated circuit (IC) that combines...
All-digital PLLs promise flexible and precise frequency modulation continous-wave(FMCW) radar signal signal for 77GHz radar applications. Such PLLs require digitally-controlled oscillators(DCO) with wide frequency tuning range and high resolution to address a range of applications and low phase noise requirements. In this thesis, novel resonator structures with ne capacitance/inductance switching...
Low-power receivers (RX) with 100$\mu W$-scale power consumption can enable several power/energy-constrained IoT applications. However, achieving sensitivity, interferer tolerance and wide operating range with low power presents a challenge for existing architectures, particularly those constrained to highly integrated solutions without high-Q off-chip components. Existing solutions rely heavily on high quality...
In recent years, the research community's interest in fully integrated mm-Wave wireless communication systems has increased significantly. With the standards for 5G NR now in place, the focus has shifted to actual deployment. Mm-Wave systems provide wider bandwidths, higher capacity, and lower latency than existing systems such as 4G. Higher...