Flexible aerodynamic surfaces have been shown to favorably influence flight characteristics at low Reynolds numbers by increasing lift, angle of attack at stall, and resistance to perturbation. The objective of the research presented within this thesis is to investigate the influence of two aspects of flight observed in biological flyers,...
The performance of a combined Stirling-ORC power cycle is evaluated, and an integrated microchannel heat exchanger is designed as an annular cold-side heat rejector for a free piston Stirling engine. Reasonable designs for a combined cycle can increased power output efficiency by 3 - 9% compared to that of a...
Novel fluidic devices that utilize an array of microchannels to achieve their designed purpose are discussed. Examples of devices include: fuel reforming using Microreactors, chip cooling using microchannel heat sinks, and microchannel devices used for biological applications. The devices that have directly contributed to this research include: a microchannel water...
Rising energy demands and the continual push to find more energy efficient technologies have been the impetus for the investigation of waste heat recovery techniques. Diesel engine exhaust heat utilization has the potential to significantly reduce the consumption of fossil fuels and reduce the release of greenhouse gases, because diesel...
Fractal-like branching microchannel flow networks have been found to improve wall temperature uniformity and decrease both pressure drop and flow power compared to arrays of straight microchannels. The present study seeks to maximize the benefits of fractal-like branching channels by means of a gradient-based optimization algorithm. The algorithm identifies the...
The internal moisture stress of Douglas-fir was determined on foliage collected in the Siskiyou Mountains of southwestern Oregon. Internal moisture stress integrates both climatic and edaphic environmental effects as they influence a plants moisture regime. In this study two laboratory techniques were modified to permit stress measurements to be taken...
A continuous process for the production of ceramic materials has been studied.
This method reacted metal and oxidizer in a diffusionally controlled process,
demonstrated by reacting a magnesium particle stream and hot water vapor. Many small
rich hydrogen/air diffusion flames provide an atmosphere of hot water vapor, hydrogen,
and nitrogen...
