The testing of nuclear fuel under reactivity-initiated accident (RIA) conditions is paramount for the better understanding of the fuel’s behavior during this transient accident events. The Transient Reactor Test (TREAT) facility is a nuclear reactor that will be capable of recreating the thermal-hydraulic and neutronic boundary conditions representative of RIA...
An enhanced swing differential Colpitts VCO (ESDC-VCO) dramatically improves
the swing of a Colpitts VCO by allowing the signal to swing below ground and above the
supply voltage. Fabricated in a 1P8M 0.13 um CMOS process, the ESDC-VCO operates
at 4.9GHz with a 0.475-V supply and consumes 2.7mW. The measured...
As the fifth generation of mobile communication systems (5G) is being deployed, massive multiple-input multiple-output (MIMO) serves as one of its enabling technologies where reliable and ultra low latency communications are achieved while being power and spectrum efficient. This thesis studies the security aspect of massive MIMO system from the...
Traditional bus-based interconnects are simple and easy to implement, but the scalability is greatly limited. While router-based networks-on-chip (NoCs) offer superior scalability, they also incur significant power and area overhead due to complex router structures. In this thesis, a new class of on-chip networks, referred to as Routerless (RL) NoCs,...
Wearable sensors with an inertial measurement unit (IMU) are popular for indoor positioning and activity pattern detection. The IMUs can be connected to a wireless transmission module, allowing users to monitor and process motion-related parameters remotely. Because of the complexity and uncertainty of signals in indoor environments, a radio frequency...
Real time indoor positioning awareness systems aim to add localization capabilities to upcoming wireless technologies that are quickly becoming an important feature for indoor environment. RF-based impulse-radio ultra-wideband (IR-UWB) is a promising technology for in-door positioning systems due to obstacle penetration capabilities, immunity to multi-path and fading, and high resolution....
Fe25Co25Ni25Cr25-XMoX High Entropy Alloys were fabricated in mini arc-melter and then cast into 4mm diameter cylinders by injection casting technique and 1cm diameter cylinders by water quenching technique. Heat transfer modeling during solidification of FeCoNiCr HEA was simulated. Combining X-Ray Diffraction, Optical Microscopy, Scanning Electron Microscope, Energy Dispersive X-ray analysis,...
Threshold-based time of arrival (TOA) estimation is a technique for high-precision indoor localization. Existing threshold selection methods, such as xed thresh- old and normalized threshold methods, do not consider the signal-to-noise radio (SNR) value at the receiver. This is not desired for high-precision positioning. A proper threshold value depends on...
Simulation models were developed to explore the reversible nature of gecko dry
adhesion system. The central idea of this model is that even with a small moment imparted on the contact tip, the seta can be easily ad-adhered. It is shown that this contact condition is very sensitive, but can...
A first generation, one-dimensional predictive model is proposed for designing heat sinks with fractal flow networks. A three-dimensional computational fluid dynamics (CFD) model is analyzed as a means for validating the model and identifying areas for improvement. Two separate CFD models were developed. One was analyzed with conjugate heat transfer...