Moisture durability is essential for wood composites, especially those used in building construction, where products are prone to weathering. The primary focus of this research was to determine if adhesive penetration into the cell wall has a positive influence on adhesive bond durability. To fully understand the measureable effects of...
We measured fracture resistance curves (or R curves) for laminated veneer lumber (LVL) made with
Douglas fir veneer and polyvinyl acetate resin and for solid wood Douglas fir. The LVL and solid wood R
curves were the same for initiation of fracture, but the LVL toughness rose much higher than...
Abstract: Three novel curing agents ( I , II , and III) were synthesized
from epichlorohydrin and ammonium hydroxide.
The combinations of soy flour (SF) with one of the curing
agents (SF- I , SF- II , and SF- III ) were investigated as adhesives
for making interior plywood. Water...
A phenol formaldehyde (PF) adhesive was uniformly tagged with iodine such that it yielded sufficient x-ray computed tomography (XCT) gray-scale contrast for material segmentation in reconstructed wood-composite bondlines. Typically, untagged adhesives are organic and have a similar solid state density as wood cell-walls, and therefore cannot be segmented quantitatively in...
This paper reports the feasibility of using surface mount adhesives to produce low temperature microchannel arrays in a wide variety of metals. Sheet metal embossing and chemical etching processes have been used to produce sealing bosses that eliminate channel laminae, resulting in approximately 50% material savings over traditional methods. An...
This paper reports the feasibility of using surface mount adhesives to produce low temperature microchannel arrays in a wide variety of metals. Sheet metal embossing and chemical etching processes have been used to produce sealing bosses that eliminate channel laminae, resulting in approximately 50% material savings over traditional methods. An...
Full Text:
approximately
50% material savings over traditional methods. An assembly process using adhesive dispense and
Fracture toughness of wood and wood composites has traditionally been characterized by a stress intensity factor, an initiation strain energy release rate (G[subscript init]) or a total energy to fracture (G[subscript f]). These parameters provide incomplete fracture characterization for these materials because the toughness changes as the crack propagates. Thus...
A low-temperature liquid-to-vapor counterflow microchannel heat exchanger has been redesigned and fabricated using a scalable, low-cost adhesive bonding process. Adhesive erosion concerns are mitigated with the use of sealing bosses. Performance has been tested using water and compressed air as test fluids. Results show greater effectiveness and higher heat transfer...
In this study, triglycidylamine (TGA) was synthesized and evaluated as a crosslinking agent for soy flour (SF) for making five-ply plywood from yellow poplar. Glycerol polyglycidyl ether (GPE) and trimethylolpropane triglycidyl ether (TTE) were also investigated as crosslinking agents for SF as adhesive for plywood. The plywood panels bonded with...
