With the ever-increasing demand for portable devices used in applications
such as wireless communication, mobile computing, consumer electronics, etc.,
the scaling of the CMOS process to deep submicron dimensions becomes more
important to achieve low-cost, low-power and high-performance digital systems.
However, this downscaling also requires similar shrinking of the supply...
The demand for portable electronic systems and the continued
down-scaling of device dimensions resulted in rapid improvement in
the performance of integrated systems. Several low-voltage design
techniques have been proposed to operate analog circuits with sub-1V
supply. However, these techniques require higher power consumption
to achieve large dynamic range while...
Digital-to-analog converters (DACs) with wide dynamic range and high
linearity are required for high-end audio applications. A multi-bit delta sigma
audio DAC, using a novel gain-correction technique, is described in this thesis. For
widely varying on-chip RC time constant, the DAC gain can be accurately
controlled by the correction circuitry....
As the functionality of digital chips continues to increase dramatically, chip- to-chip communication bandwidths must scale accordingly to avoid constraining the overall system performance. Therefore, high speed transceiver design has be- come an important research topic. In particular, the performance of the circuits that are responsible for timing accuracy are...
Scaling of CMOS technology has progressed relentlessly for the past several
decades. In order for this unprecedented scaling to benefit the performance of
large digital systems, the communication bandwidth between integrated circuits
(ICs) must scale accordingly. However, interconnect technology does not scale as
aggressively, making communication between chips the major...
A digital implementation of a PLL has several advantages compared to its
analog counterpart. These include easy scalability with process shrink, elimination
of the noise susceptible analog control for a voltage controlled oscillator (VCO) and
the inherent noise immunity of digital circuits. Several recent digital PLL (DPLL)
implementations have achieved...
The continued scaling of deep-submicron CMOS technology enables low-voltage high-frequency phase-locked loops (PLLs) to be fully integrated in complex mixed-signal systems. However, fluctuations due to the manufacturing process and variations in
environmental conditions, such as supply voltage and temperature, are also significantly increased. As a result, the performance of PLLs...
Low noise oscillators are universally needed in digital systems for clock generation and synchronization, and in radio-frequency communication front-ends for frequency up- and down-conversion. Noise in oscillators results in timing jitter, and limits the clock frequency of digital systems. In radio-frequency communication systems, phase noise in oscillators lowers the signal-to-noise...
This thesis presents methods to reduce the effects of finite opamp DC gain, output voltage swing limitations in opamps, and component mismatches. The primary contribution of this thesis is a new switched-capacitor method named correlated level shifting (CLS). CLS enables true rail-to-rail operation by storing an estimate of the desired...
Analog-to-digital converters (ADCs) convert analog
continuous time signals into discrete time, digital format. One
precondition that must be met for conventional nyquist rate ADCs is
that the input signal must be suitably band-limited to an input
bandwidth less than the nyquist frequency. This mandates expensive
anti-alias filters which contribute to...