Cross-laminated timber (CLT) is an attractive building material because it is renewable, promotes fast installation, and possesses a high strength-to-weight ratio. The use of CLT in seismic applications has become increasingly common with the development of post-tensioned CLT rocking wall lateral force resisting systems (LFRS). The CLT pier-and-spandrel system designed,...
The growing contamination of surface water by stormwater runoff parallels increasing urban development. Heavy metals, polycyclic aromatic hydrocarbons (PAHs), persistent organic pollutants (POPs), and contaminants of emerging concern (CECs) are discharged from point sources and washed from impervious surfaces into surface waters, impacting the ecology of these systems, food supplies,...
Unlike other industries, overall efficiency of construction projects has been growing minimally which directly causes cost overruns of projects. Though reducing idle time and increasing operational efficiency of construction equipment could result in significant cost saving, there is lack of practical knowledge of adjusting operational efficiency and integrating cost and...
The goal of the first part of this project was to investigate the influence of aggregate source and entrained air on the transport properties of concrete. Currently, there are several ASTM standards available that provide systematic procedures to evaluate mass transport properties of concrete. ASTM C642-13 (ASTM 2013), often referred...
The Large Wave Flume at the O.H. Hinsdale Wave Research Laboratory houses a piston wavemaker with a built-in active absorption system designed by MTS Systems Corporation. The performance of the active absorption system has not been properly assessed yet. This thesis evaluates the performance of the MTS active absorption system...
A series of laboratory experiments were conducted to study the wave field in the inner lagoon excited by ‘long’ incident waves. Three cases were considered: Cases A, B and C presenting incident waves of wavelength with factors of 1, 2 and 2.5 times the width of the reef respectively. The...
Bridges are a vital component of transportation infrastructure in the United States, and the continual maintenance and preservation of bridges is critical to maintaining their structural capacity and maximizing service life. One of the most significant issues faced by concrete bridges is the infiltration of moisture from the roadway surface...
This study evaluates the productivity and accuracy of surveys completed with single-base real-time kinematic (RTK) Global Navigation Satellite Systems (GNSS) using four different GNSS constellation combinations: (1) GPS-only, (2) GPS+GLONASS, (3) GPS+Galileo+BeiDou, and (4) GPS+GLONASS+Galileo+BeiDou. For this comparison, we set up a test site consisting of 20 stations ranging with...
Strong ground motions from earthquakes can result in the reduction of the shear modulus and wave propagation characteristics of soils, and can produce liquefaction and cyclic softening during shaking and for some time following the seismic event. While the ground motions produced from controlled blasting are different than those in...
Planning and management methods in construction need to constantly evolve to keep pace with the growing demand and complexity of work in increasingly competitive environments. This need for innovation and process improvement has attracted lean construction philosophy in industry management practice. Lean has been used in the construction industry to...