Ferrites have been used for various high frequency applications as bulk
materials. These applications, however, are limited to large dimension devices. In
this thesis, thin film ferrites were deposited from a low temperature solution-based
deposition process that is suitable for micro-scale high frequency applications. The
low temperature nature of this...
With the ever-increasing demand for portable devices used in applications
such as wireless communication, mobile computing, consumer electronics, etc.,
the scaling of the CMOS process to deep submicron dimensions becomes more
important to achieve low-cost, low-power and high-performance digital systems.
However, this downscaling also requires similar shrinking of the supply...
Digital-to-analog converters (DACs) suffer from static and dynamic nonlinearity problems, which degrade their accuracy and performance. Mismatch errors in the analog components restrict the maximum achievable linearity.
This thesis presents various techniques for correcting these errors. It describes a correction process for the nonlinear behavior of DACs, on three different...
Commonly proposed ocean wave energy converters (OWEC) use inefficient and maintenance demanding intermediate hydraulic and pneumatic systems. We propose a novel rotary direct-drive OWEC that eliminates these intermediate stages. The new device employs a contactless force transmission system (CFTS) comprising a “piston” and a “cylinder” and a ball screw to...
Designing spectral efficient, high-speed wireless links that offer high quality-
of-service and range capability has been a critical research and engineering challenge. In this thesis, we mainly address the complexity and performance issues of
channel estimation and data detection in multiple-input multiple-output (MIMO)
orthogonal frequency division multiplexing (OFDM) systems over...
Traditionally linear actuator applications are addressed by the use of hydraulic systems. The high maintenance cost and poor reliability will always be the most critical problem in the real applications. Benefited from both the high mechanical advantage of the roll screw and the simple structure of the switched reluctance motor,...
In recent years, there has been growing interest in both industry and academia to use continuous-time (CT) Δ-Σ A/D converters for wideband wireless and wireline communication applications.
So far no reported CT Δ-Σ A/D modulator achieves 14-bit or higher dynamic range (DR) with more than 2MHz signal bandwidth (equivalently 4MS/s)....
The demand for portable electronic systems and the continued
down-scaling of device dimensions resulted in rapid improvement in
the performance of integrated systems. Several low-voltage design
techniques have been proposed to operate analog circuits with sub-1V
supply. However, these techniques require higher power consumption
to achieve large dynamic range while...
Ultra-wideband (UWB) communication has emerged as a very promising
technology for short-range wireless applications, including
high-speed multimedia transmissions and sensor networks. UWB
system designs involve many different aspects covering analog and
digital processing, channel estimation and modeling, and
modulation and demodulation. Although UWB still faces many
challenges, significant progress has...
The thesis focuses on model-based approximation methods for reinforcement
learning with large scale applications such as combinatorial optimization problems.
First, the thesis proposes two new model-based methods to stablize the
value–function approximation for reinforcement learning. The first one is the
BFBP algorithm, a batch-like reinforcement learning process which iterates between...