Search Constraints

Start Over
Filtering by: Alternative title ssim FS-234 Remove constraint Alternative title ssim: FS-234 Academic Affiliation Electrical Engineering and Computer Science Remove constraint Academic Affiliation: Electrical Engineering and Computer Science Rights Statement In Copyright Remove constraint Rights Statement: In Copyright Subject Analog-to-digital converters -- Design and construction Remove constraint Subject: Analog-to-digital converters -- Design and construction

Search Results

  • Design of a 14-bit continuous-time Delta-Sigma A/D modulator with 2.5MHz signal bandwidth

    Creator:
    Li, Zhimin
    Abstract:
    In recent years, there has been growing interest in both industry and academia to use continuous-time (CT) Δ-Σ A/D converters for wideband wireless and wireline communication applications. So far no reported CT Δ-Σ A/D modulator achieves 14-bit or higher dynamic range (DR) with more than 2MHz signal bandwidth (equivalently 4MS/s)....
    Resource Type:
    Dissertation

  • Architectural Solutions for Analog Imperfections in ΔΣ Analog-to-Digital Based Systems

    Creator:
    Zali Asl, Samira
    Abstract:
    For today’s ubiquitous portable devices, innovative integrated circuits with high performance yet very low power are necessary. As these devices are used to communicate and sense real world signals in the environment, analog-to-digital converters (ADC) and systems are the key interface circuits needed to digitize the sensed information and they...
    Resource Type:
    Dissertation

  • Automated synthesis of analog to digital conversion

    Creator:
    Weaver, Skyler
    Abstract:
    This thesis describes circuit architectures and techniques that facilitate the automatic synthesis and fabrication of analog-to-digital converters (ADCs). Since automated synthesis already exists for digital circuits and is part of the digital circuit design flow, this work demonstrates the feasibility of ADC synthesis with little or no modification to presently...
    Resource Type:
    Dissertation
    Full Text:
    of 1 MHz sine input. fS = 8 MHz. b) Measured transfer function of the same parallel comparators as

  • High efficiency delta-sigma modulation data converters

    Creator:
    Lee, Kyehyung
    Abstract:
    Enabled by continued device scaling in CMOS technology, more and more functions that were previously realized in separate chips are getting integrated on a single chip nowadays. Integration on silicon has opened the door to new portable wireless applications, and initiated a widespread use of these devices in our common...
    Resource Type:
    Dissertation
    Full Text:
    drivers for the headphones. The digital filter increases the sampling rate from fs = 48 kHz to 64·fs

  • Low-power design techniques for low-voltage analog-to-digital converters

    Creator:
    Kim, Min Gyu
    Abstract:
    The demand for portable electronic systems and the continued down-scaling of device dimensions resulted in rapid improvement in the performance of integrated systems. Several low-voltage design techniques have been proposed to operate analog circuits with sub-1V supply. However, these techniques require higher power consumption to achieve large dynamic range while...
    Resource Type:
    Dissertation
    Full Text:
    . The factor OSR is referred to as the oversampling ratio (OSR), OSR = fs/2fB. Fig. 3.3 (a) and (b) are

  • Power Efficient Architectures for High Accuracy Analog-to-Digital Converters

    Creator:
    Zhang, Yi
    Abstract:
    Incremental ADCs (IADCs) have found wide applications in sensor interface circuitry since, compared to ∆Σ ADCs, they provide low-latency high-accuracy conversion and easy multiplexing among multiple channels. On the other hand, continuous-time ∆Σ ADCs (CTDSM) have been receiving more and more attention as a power-efficient solution in targeting medium to...
    Resource Type:
    Dissertation
    Full Text:
    between analog input and digital output, due to the complex digital filters needed for decimation. FS

  • Design techniques for low-voltage and low-power analog-to-digital converters

    Creator:
    Ahn, Gil Cho
    Abstract:
    With the ever-increasing demand for portable devices used in applications such as wireless communication, mobile computing, consumer electronics, etc., the scaling of the CMOS process to deep submicron dimensions becomes more important to achieve low-cost, low-power and high-performance digital systems. However, this downscaling also requires similar shrinking of the supply...
    Resource Type:
    Dissertation
    Full Text:
    (fS) the input signal can be restored according to the Nyquist sampling theorem. 22 f fS Noise

  • Design of low OSR, high precision analog-to-digital converters

    Creator:
    Rajaee, Omid
    Abstract:
    Advances in electronic systems have lead to the demand for high resolution, high bandwidth Analog-to-Digital Converters (ADCs). Oversampled ADCs are well- known for high accuracy applications since they benefit from noise shaping and they usually do not need highly accurate components. However, as a consequence of oversampling, they have limited...
    Resource Type:
    Dissertation

  • Micropower incremental analog-to-digital converters

    Creator:
    Chen, Chia-Hung
    Abstract:
    Incremental ADCs (IADCs) have many advantages for low-frequency high-accuracy data conversion—they are easy to multiplex between channels, need simpler digital decimation filter, and allow extended counting with a Nyquist-rate ADC. A single-loop incremental ADC was designed and fabricated in 90 nm for a biosensor interface circuit. It incorporates one integrator,...
    Resource Type:
    Dissertation
    Full Text:
    as 6 VSQNR  20log( FS )  20log( L M ) (2.8) EIADC

  • Adaptive, wideband analog-to-digital conversion for convergent communication systems

    Creator:
    Batten, Robert D., 1973-
    Abstract:
    The exponential rate of advances in modern communication devices in the last several years have brought us higher levels of functionality and performance as well as reductions in physical size and power consumption. To continue this rate of advancement, next generation systems require wider bandwidth and higher resolution ADCs. Additionally,...
    Resource Type:
    Dissertation
    Full Text:
    excessive loading and input switching transients. fs Vin + ­ Av Vout Cs Figure 2.2: Open-loop track