A study was conducted to determine the heat transfer characteristics
of pin finned heat sinks in natural convection. Three pin
diameters were studied: 0.238 cm, 0.318 cm and 0.396 cm. The pins
were attached to the base in two arrangements, triangular and
rectangular, forming a horizontal array. Pin spacing was...
Three approaches for evaluating mode I interlaminar strain energy release rates in graphite/epoxy composites were compared using experimental data from double cantilever beam specimens. Expressions for evaluating strain energy release rates were arrived at based on assumptions regarding specimen geometry and material behavior. The calculations included the direct method of...
Significant reductions in the number of defects in parts
produced by investment casting can be obtained by improving
the flow of the molten metal during pouring. Studies have
been done at Oregon State University with simulated casting
techniques to determine optimal mold configurations.
Better mold layouts have been shown to...
Past research has shown that automobile exhaust is composed
of a mixture of many different hydrocarbons and that some of these
hydrocarbons contribute more to the smog problem than others.
Natural gas has been proposed as an alternative to gasoline as a
motor fuel, and it was desired to confirm...
This describes the development of a new fuel flowmeter. Among the desired features were an accuracy of ±2%, a linear response to fuel flow rate, a means of increasing the sensitivity at the low end of the meter scale and portability so that it would be equally useful in the...