Many publications, documents, codes and guidelines exist related to the seismic evaluation and rehabilitation design of existing buildings. This report discusses the assumptions and methods employed for investigation of two wood structures using four references: FEMA 154, FEMA 356, ASCEI per SEI 31, and 1997 UBC. The screening performed using...
The goal of this study was to optimize a through-boring pattern that will provide adequate preservative penetration while minimizing the reduction in overall pole bending strength. Hole spacing was developed using longitudinal and transverse chemical penetration data from previous studies. Finite element analysis was used as a preliminary assessment tool...
Key parts of the lateral force resisting system in wood-frame buildings
are the shearwafls and the connections. The connections in wooden buildings
are the primary source of ductility and energy dissipation; these are essential
properties when buildings are exposed to lateral forces, such as wind and
earthquakes. Shearwall design is...
The objectives of this study were to evaluate the performance of wood frame shear walls
under monotonic, cyclic and earthquake loads by: (1) estimating the variability of shear wall
performance, (2) comparing the performance of walls under each loading protocol, (3) evaluating
the effects of anchorage on wall performance, and...
The overall goal of this study is to evaluate the earthquake performance of wood frame
shear walls, and more specifically: (1) to compare the performance differences of fully and
partially anchored walls under monotonic, cyclic, and earthquake loads, (2) to compare wall
performance under earthquake loads with that of standardized...
Friction dampers have been used successfully to dissipate seismic
energy in steel and concrete structures. The application is new to timber
structures. The objectives of this research were to design a slotted bolted
connection (SBC) and evaluate its potential as a passive energy damper in
timber brace.
The research was...
The objectives of this study are: (1) to evaluate the effect of reference
displacement on wall behavior under fully reversed cyclic loading using the
CUREE test protocol and (2) to assess damage accumulation (visible fastener
damage and stiffness degradation) for the imposed drift levels. All tests were
conducted on identical...
The objective of this study was to determine the effect of misplaced hold-downs
on the static and cyclic behavior of wood shear walls. Three shear wall
configurations were considered in this study. The first configuration (control) had
hold-downs at the ends of the wall (wall type 1), the second configuration...
Engineering analysis of heavy timber structures under dynamic loads
is generally lacking. Some literature suggests that heavy timber structures
are stiffer than expected, but popular engineering opinion is to the contrary.
In addition, prior research has shown that passive friction dampers can be
used in timber structures for the intended...
In recent years, log structures have been marketed as an alternative
to conventional light-frame wood structures. Log structures are constructed
using round timbers (or manufactured timbers) that are stacked vertically
and have interlocking corners. Thru-rods and lag screws are used to
provide inter-log connections. This project was conducted to evaluate...
The overall goal of this study was to gain an insight into the load sharing aspect between oriented strand board (OSB) and gypsum wall board (GWB) in shear wall assembly during racking load. More specifically the objectives of the study were to: (1) evaluate qualitatively the load sharing between OSB...
Light-frame construction practices and materials have changed greatly
over the past 100 years. Contemporary research has focused on modern construction; thus, we know a great deal about the behavior of modern lightframe buildings under lateral forces. However, there are many light-frame buildings that were built prior to the introduction of...
Heavy timber framing relies primarily on bracing to withstand lateral loads due to earthquakes and wind events. Bracing configurations in heavy timber framed buildings vary widely and include cross bracing, knee bracing, and other geometries. Many heavy timber frames constructed during colonial American times are still standing, exceeding the expected...
