The semiconductor gallium arsenide (GaAs) has many potential
advantages over the more widely used semiconductor silicon (Si).
These include higher low field mobility, semi-insulating substrates,
a direct band-gap, and greater radiation hardness. All these
advantages offer distinct opportunities for implementation of new
circuit functions or extension of the operating conditions...
It has become customary in electrical engineering to think of
signal processing in terms of voltage variables to the exclusion of
current variables. This tendency has resulted in voltage signal
processing circuits such as voltage-controlled voltage sources
(VCVS) and voltage-mode operational amplifiers. However, the VCVS
operational amplifier has several limitations...
Decision feedback equalizer (DFE) is an effective method to remove inter-symbol
interference (ISI) from a disk-drive read channel. Analog IC implementations of DFE
potentially offers higher speed, smaller die area, and lower power consumption when
compared to their digital counterparts.
Most of the available DFE equalizers were realized by using...
The CMOS two-stage Operational Transconductance Amplifier (OTA) has been a key enabler for mixed-signal IC design for nearly four decades . This research focuses on a modified two-stage CMOS OTA that features load-pole cancellation (LPC); i.e., the resulting architecture is essentially a two-stage CMOS OTA with no load capacitance. The...
Sensor system plays an important role in connecting everything including human body to the electrical information systems that we have built and that we are going to build, to make the world more intelligent and efficient. One of the key propulsive forces behind these emerging techniques is CMOS scaling that...
A circuit topology for high-swing, high-linearity
CMOS operational amplifiers has been developed. The
technique uses parallel-connected p- and n-channel
input pairs to realize an input common-mode voltage
range nearly equal to the total power supply voltage.
High linearity is achieved by summing the DC bias and
AC small-signal currents so...
The chopper-stabilized operational amplifier has good low
frequency noise properties. Unfortunately a simple technique for
simulation of the chopper-stabilized operational amplifier has
not been available.
This thesis describes the implementation of a differential
amplifier using chopper stabilization and its circuit modeling
for the SPICE simulation. This circuit has been designed...
In this paper, an analysis of the clock-feedthrough effects in
switched-current (SI)' circuits will be presented. The clock-feedthrough
effects caused by the non-ideal characteristic of MOS
switches when they are turned off limit the accuracy of the analog
track-and-hold (T/H) circuits. A model to analyze and characterize this
effect is...
Clock-feedthrough effects, channel-length modulation and device mismatch are
the main causes of the inaccuracy of Switched-Current (SI) circuits. In this paper, these
non-ideal effects are analyzed. A high-performance current mirror, namely regulated
cascode current mirror, which eliminates drain voltage variation problem is introduced.
By using this current mirror as a...
Advancements in the sophistication and complexity of modern electronic systems are creating a need for highly integrated systems with ever higher operational frequencies. The economical demands of these systems dictate that they be implemented using low cost fabrication technologies, such as digital CMOS. One of the major challenges facing circuit...