Modern sensor network applications are often implemented wirelessly in order to lessen installation costs and reduce deployment times. Unfortunately, these wireless sensor network (WSN) nodes must often rely on batteries or energy harvesting techniques in order to sustain their operation and supply the power needed to maintain communication within the...
Analog-to-digital converters (ADCs) are the key building block for sensor applications, such as wireless communications and digital electronics. These applications require ADCs to have medium to high accuracy (normally from 10-14 bits) and relatively low signal bandwidth (ranging from 100Hz-150kHz). Since these applications are often powered by batteries, high power...
The design of mobile wireless devices has always focused on reducing power, area, and cost. This dissertation proposes two techniques that are leveraged to save power and area and therefore cost. The first techniques reduces the noise in the receiver and results in a relaxed power requirement. The second technique...
This dissertation focuses on the analysis, design, and application of inductor-capacitor (LC) oscillators for wireless sensor networks (WSNs).
First an analysis and design optimization approach for enhanced swing, low power CMOS LC oscillators is presented. A phasor based analysis is used for determining the amplitude and phase noise of these...
Wireless sensor networks are becoming important in several monitoring and sensing applications. Ultra low power consumption in the sensor nodes is important for extending the battery life of the nodes. In this dissertation, two low power BFSK receiver architectures are proposed and verified with prototype implementations in silicion.
A 2.4...
This thesis presents a low power DC-DC converter suitable for harvesting energy from high impedance thermoelectric generators (TEGs) for the use in body powered electronics. The chip has been fabricated in a 130nm CMOS technology. To meet the power demands of body powered networks, a novel dual-path architecture capable of...
An analysis that accounts for the effect of standard electrostatic discharge (ESD) structures on critical LNA specifications of noise figure, input matching and gain is presented. It is shown that the ESD structures degrade LNA performance particularly for higher frequency applications. Two LNAs, one with ESD protection and one without,...
Algorithms and simulators comprised of SPICE3 as a circuit level simulator and two device simulators EOFLOW and PROPHET for accurate simulation of new types of devices are presented in this thesis. An integration of EOFLOW with SPICE3 creates a capability for efficient simulation of a system containing interconnected electroosmotic flow...
This thesis presents an automated methodology to calibrate the substrate profile for accurate prediction of substrate parasitics using Green's function based extractors. The technique requires fabrication of only a few test structures and results in an accurate three layered approximation of a heavily doped epitaxial silicon substrate. The obtained substrate...
A scalable macromodel for substrate noise coupling in lightly doped substrates with and without a buried layer has been developed. This model is based on Z-parameters and is scalable with contact size and separation. This model requires process dependent parameters that can be extracted easily from a small number of...