Circuits operating outside the earth’s atmosphere are more vulnerable to cosmic radiation and require special design consideration. The purpose of this work is to explore methods of mitigating the effect of radiation in phase locked loop (PLL) circuits. Several voltage controlled oscillators (VCOs) and two complete PLLs are designed and...
The objective of this work is to explore the feasibility of replacing conventional op-amps with inverters in switched-capacitor (SC) circuits. In order to verify the idea, a low-pass filter (LPF) and a second-order delta-sigma (∆Σ) analog-todigital converter (ADC) are designed in the 0.5-m CMOS technology. The low-pass filter structure is...
There is a large and growing market for portable consumer audio products
with very small size. As the size of these products is reduced, the area occupied
by batteries becomes significant and hence limits the number of batteries to one.
In order to build such small products, high levels of...
The demand for portable electronic systems and the continued
down-scaling of device dimensions resulted in rapid improvement in
the performance of integrated systems. Several low-voltage design
techniques have been proposed to operate analog circuits with sub-1V
supply. However, these techniques require higher power consumption
to achieve large dynamic range while...
To realize pipelined ADCs in deep-submicron processes, low voltage techniques
must be developed to work around problems created by limited supply voltages such as
the floating switch dead zone, reduced SNR, and reduced OpAmp performance.
This thesis analyzes standard and low voltage design issues for pipelined ADCs
and proposes a...
The most accurate method for performing analog signal processing in MOS (metal-oxide-semiconductor) integrated circuits is through the use of switched-capacitor circuits. A switched-capacitor circuit operates as a discrete-time signal processor. These circuits have been used in a variety of applications, such as filters, gain stages, voltage-controlled oscillators, and modulators. A...
Real world is analog but the processing of signals can best be done in digital domain. So the need for Analog to Digital Converters(ADCs) is ever rising as more and more applications set in. With the advent of mobile technology, power in electronic equipment is being driven down to get...
As the functionality of digital chips continues to increase dramatically, chip- to-chip communication bandwidths must scale accordingly to avoid constraining the overall system performance. Therefore, high speed transceiver design has be- come an important research topic. In particular, the performance of the circuits that are responsible for timing accuracy are...
The world market for sensors is several hundred million dollars growing at an annual rate of 20 percent with accelerometers comprising 19 percent of the market. With an increasing market, a wide range of applications with varying degrees of resolution are in demand. Therefore, there is sufficient motivation for developing...
In this work a new voltage buffer, the drain-follower, achieves 300MHz band-width with 2pF load, a dc gain of 0.993V/V, 1mV offset voltage, -60 dB total harmonic distortion at 1.4Vpp output voltage and 6.5mW power dissipation from 5V supply. A unity-gain buffer switched-capacitor biquad filter has been implemented in 0.5μm...