A novel switched-R-MOSFET-C input branch is proposed for low-voltage and high-linearity applications. The tunability is achieved by varying the clock duty cycle using an automatic tuning circuit. This tuning method does not involve a change in gate voltage, and is therefore particularly suitable for low-voltage applications. The advantages of the...
The world market for sensors is several hundred million dollars growing at an annual rate of 20 percent with accelerometers comprising 19 percent of the market. With an increasing market, a wide range of applications with varying degrees of resolution are in demand. Therefore, there is sufficient motivation for developing...
Hand-held devices are among the most successful consumer electronics in modern society. Behind these successful devices, lies a key analog design technique that involves high-performance analog-to-digital conversion combined with very low power consumption. This dissertation presents two different approaches to achieving high power efficiency from a two-step pipelined architecture, which...
Analog to digital converters (ADCs) are a critical part of communication between the physical world and the increasingly digital systems humans use every day. ADCs have inherent non-idealities that degrade performance. Nonlinearity is one of the most prevalent non-idealities that designers face. While calibration methods for nonlinearity exist in the...
The design of mixed-signal integrated circuits has evolved from simple analog and digital circuits operating on the same silicon substrate to the point that now we have complete system on a chip solutions for communication systems. The levels of integration needed to remain cost effective in today's integrated circuit (IC)...
Voltage converters or charge pumps find their use in many circuits. They are extensively used in hand held devices as cell phones, pagers, PDA's and laptops. Some of the important issues relating to design of voltage regulators for handheld devices are size, efficiency and noise. Another important factor to be...
To realize pipelined ADCs in deep-submicron processes, low voltage techniques
must be developed to work around problems created by limited supply voltages such as
the floating switch dead zone, reduced SNR, and reduced OpAmp performance.
This thesis analyzes standard and low voltage design issues for pipelined ADCs
and proposes a...
Evolution of the mobile communication standards and proliferation of hand-held devices mandate stringent Analog-to-Digital Converter (ADC) specifications. Among various ADCs, a ∆Σ ADC is best known as a power-efficient ADC when more than 12b is required. However, a conventional discrete-time (DT) ∆Σ Modulator (∆ΣM) is inadequate for low-power wideband applications...
The most accurate method for performing analog signal processing in MOS (metal-oxide-semiconductor) integrated circuits is through the use of switched-capacitor circuits. A switched-capacitor circuit operates as a discrete-time signal processor. These circuits have been used in a variety of applications, such as filters, gain stages, voltage-controlled oscillators, and modulators. A...
Phase-locked loop (PLL) frequency synthesizers lie at the heart of most radio transceivers. An important objective of the electronics and communications industry is to design high-speed building blocks which dissipate the lowest possible power, and to ac- complish this with the cheapest technology. The dual-modulus prescaler is one of the...