Evolution of the mobile communication standards and proliferation of hand-held devices mandate stringent Analog-to-Digital Converter (ADC) specifications. Among various ADCs, a ∆Σ ADC is best known as a power-efficient ADC when more than 12b is required. However, a conventional discrete-time (DT) ∆Σ Modulator (∆ΣM) is inadequate for low-power wideband applications...
Analog to digital converters (ADCs) are a critical part of communication between the physical world and the increasingly digital systems humans use every day. ADCs have inherent non-idealities that degrade performance. Nonlinearity is one of the most prevalent non-idealities that designers face. While calibration methods for nonlinearity exist in the...
Analog-to-digital converters (ADCs) convert analog
continuous time signals into discrete time, digital format. One
precondition that must be met for conventional nyquist rate ADCs is
that the input signal must be suitably band-limited to an input
bandwidth less than the nyquist frequency. This mandates expensive
anti-alias filters which contribute to...
In an industrial and consumer electronic marketplace that is increasingly demanding greater real-world interactivity in portable and distributed devices, analog to digital converter efficiency and performance is being carefully examined. The successive approximation (SAR) analog to digital converter (ADC) architecture has become popular for its high efficiency at mid-speed and...
In recent years, SAR ADCs have been shown to acheive faster conversion times and improved power efficiencies due to their simple building blocks that are digital in nature and scale favorably with technology. High resolution ADCs with stringent noise requirement has led to the adoption of hybrid ADC architectures such...
The objective of this work is to explore the feasibility of replacing conventional op-amps with inverters in switched-capacitor (SC) circuits. In order to verify the idea, a low-pass filter (LPF) and a second-order delta-sigma (∆Σ) analog-todigital converter (ADC) are designed in the 0.5-m CMOS technology. The low-pass filter structure is...
This thesis describes circuit architectures and techniques that facilitate the
automatic synthesis and fabrication of analog-to-digital converters (ADCs). Since
automated synthesis already exists for digital circuits and is part of the digital
circuit design flow, this work demonstrates the feasibility of ADC synthesis with
little or no modification to presently...
Time-domain data conversion has recently drawn increased research attention for its highly digital nature in favor of process technology scaling. Also, as the time information being carried by binary voltage, time-domain operation is much less sensitive to voltage noise compared to conventional voltage domain operation. However, for analog-to-digital converter (ADC)...
.
...................................................................................................................................... 89
Figure 5.7: Measured PSD with -3dBFS signal at 200kHz, 25MHz fm and 400MHz fs
The demand for portable electronic systems and the continued
down-scaling of device dimensions resulted in rapid improvement in
the performance of integrated systems. Several low-voltage design
techniques have been proposed to operate analog circuits with sub-1V
supply. However, these techniques require higher power consumption
to achieve large dynamic range while...
Circuits operating outside the earth’s atmosphere are more vulnerable to cosmic radiation and require special design consideration. The purpose of this work is to explore methods of mitigating the effect of radiation in phase locked loop (PLL) circuits. Several voltage controlled oscillators (VCOs) and two complete PLLs are designed and...