A novel switched-R-MOSFET-C input branch is proposed for low-voltage and high-linearity applications. The tunability is achieved by varying the clock duty cycle using an automatic tuning circuit. This tuning method does not involve a change in gate voltage, and is therefore particularly suitable for low-voltage applications. The advantages of the...
Hand-held devices are among the most successful consumer electronics in modern society. Behind these successful devices, lies a key analog design technique that involves high-performance analog-to-digital conversion combined with very low power consumption. This dissertation presents two different approaches to achieving high power efficiency from a two-step pipelined architecture, which...
Evolution of the mobile communication standards and proliferation of hand-held devices mandate stringent Analog-to-Digital Converter (ADC) specifications. Among various ADCs, a ∆Σ ADC is best known as a power-efficient ADC when more than 12b is required. However, a conventional discrete-time (DT) ∆Σ Modulator (∆ΣM) is inadequate for low-power wideband applications...
This dissertation presents a phase domain in-loop-bandwidth spread-spectrum clock generation technique. In this proposed technique, a charge-based discrete-time loop filter is proposed to enable the phase domain in-loop-bandwidth spread-spectrum modulation without a delta-sigma modulator or time-to-digital converter. The in-loop-bandwidth modulation technique maximizes the loop bandwidth to improve phase noise suppression...
This thesis proposes a novel technique for the design of pipelined and cyclic ADCs utilizing generalized radix gain stages. Several models have been proposed for the optimization of high performance pipelined ADCs by various researchers. This work builds upon them, using a simple but accurate model to estimate the optimal...
This thesis proposes a novel fully digital technique for the estimation and correction of the DAC error in multi-bit delta sigma ADCs. The structure of the DAC error is indicated through a simple model for unit-element based DACs. The impact of the DAC error on the performance of ADC is...
Utilizing a two-capacitor topology, the digital implementation of an audio-band successive-approximation analog-to-digital converter (ADC) is explored in the context of mismatch-shaping where the mismatch estimates are accurate to the first order. A second-order Δ∑ loop was found to be effective in system simulations given a 0.1% capacitor mismatch. Spectral analysis...
Low noise oscillators are universally needed in digital systems for clock generation and synchronization, and in radio-frequency communication front-ends for frequency up- and down-conversion. Noise in oscillators results in timing jitter, and limits the clock frequency of digital systems. In radio-frequency communication systems, phase noise in oscillators lowers the signal-to-noise...
This thesis presents a novel algorithmic A/D converter to be used in a biosensor. The converter is capable of a conversion rate of 1.5 bits/phase and hence the required conversion time is reduced. The proposed architecture is analyzed for non-ideal effects and compared with existing algorithmic A/D architectures. The converter...
A duty-cycle controlled switched resistor is a tunable resistive element that uses pulse width modulation as the method of tuning. This thesis will describe the operation of switched resistors and propose several circuit architectures that are well suited to the use of switched resistors. These architectures include filters, mixers, and...