Search Constraints

Start Over
Filtering by: Contributor advisor sim Allstot, David J. Remove constraint Contributor advisor sim: Allstot, David J.

Search Results

  • Switch-capacitor Power Amplifier with Enhanced Power Back-off Efficiency and Linearity

    Creator:
    Qiao, Bo
    Abstract:
    Nowadays, wireless communication systems use high-order quadrature amplitude modulation (QAM) together with orthogonal frequency-division multiplexing (OFDM) to increase the link capacity and robustness. These signals always have large peak-to-average power ratio (PAPR) and require power amplifiers (PAs) achieve both high efficiency and linearity simultaneously. For the efficiency, the complementary metal...
    Resource Type:
    Dissertation

  • gm/ID Design Techniques for Low-power High-performance CMOS Analog Integrated Circuits

    Creator:
    Aueamnuay, Chaiyanut
    Abstract:
    The gm/ID-based design of analog integrated circuits introduced in 1996 employs an empirical transistor sizing methodology using SPICE-generated lookup tables that enables good agreement between simulations and specifications. This thesis introduces a new SPICE lookup table that extends the gm/ID approach to the Miller pole-splitting frequency compensation of the classical...
    Resource Type:
    Masters Thesis

  • Sensor Interface Circuit Design towards CMOS Scaling

    Creator:
    Liu, Jialin
    Abstract:
    Sensor system plays an important role in connecting everything including human body to the electrical information systems that we have built and that we are going to build, to make the world more intelligent and efficient. One of the key propulsive forces behind these emerging techniques is CMOS scaling that...
    Resource Type:
    Dissertation

  • A 90.5dB DR 1MHz BW Hybrid Two Step ADC with CT Incremental and SAR ADCs

    Creator:
    Wang, Yanchao
    Abstract:
    The sensors in real time data processing IoT devices require high resolution and sub-MHz data converters, usually implemented as Incremental ADCs due to the advantages of oversampling technique and low latency. In discrete time incremental (IDT) ADCs, the sampling switch non-linearity, charge injection degrade the resolution, and power hungry OPAMPs...
    Resource Type:
    Dissertation

  • Low-voltage Tracking RC Compensated OTA and a Rail-to-Rail Input and Output Operational Amplifier

    Creator:
    Kuo, Yu-Wen
    Abstract:
    The operational transconductance amplifier (OTA) is a fundamental building block in analog and mixed-signal systems. This research describes a process-, voltage-, and temperature- (PVT) insensitive low-voltage tracking RC compensation scheme considered for two-stage CMOS OTAs, which cancels the pole due to the load capacitance using a Miller zero generated by...
    Resource Type:
    Masters Thesis

  • Efficient Deep Learning Methods for Biomedical Applications

    Creator:
    Thota, Narayana Bhagirath
    Abstract:
    Deep Learning methods have been gaining a lot of significance for various Biomedical applications for diagnosing several types of diseases. Two applications considered here are: 1) Diabetic Retinopathy Detection and 2) ECG signal Classification (or Arrhythmia Detection). Diabetic Retinopathy (DR) is a major cause of blindness in Diabetic patients, and...
    Resource Type:
    Masters Thesis

  • A Fully Integrated Bio-potential Low-noise Amplifier Utilizing Capacitor Multipliers

    Creator:
    Yong, OnnLim
    Abstract:
    In any biomedical signal acquisition system, a front-end amplifier is needed to amplify low amplitude bio-signals while filtering out any unwanted low-frequency artifacts. The design of low frequency poles within the sub-Hz range implies very large time-constants which goes against system integrability. In recent years, the pseudo resistor has been...
    Resource Type:
    Masters Thesis

  • Energy-efficient OTA architectures using load-pole cancellation

    Creator:
    Ramakrishna, Pavan Kumar
    Abstract:
    The CMOS two-stage Operational Transconductance Amplifier (OTA) has been a key enabler for mixed-signal IC design for nearly four decades . This research focuses on a modified two-stage CMOS OTA that features load-pole cancellation (LPC); i.e., the resulting architecture is essentially a two-stage CMOS OTA with no load capacitance. The...
    Resource Type:
    Masters Thesis

  • Distortion analysis of switched-current circuits

    Creator:
    Lee, Wing-sun R.
    Abstract:
    Recently, switched-current circuits have received great attention because they offer potentially better performance in terms of speed, low voltage power supplies, and accuracy in mixed-mode analog-digital signal processing. In this thesis, the distortion characteristics, DC offset and AC gain errors induced by the threshold voltage, channel width, channel length, and...
    Resource Type:
    Masters Thesis

  • A CMOS differential line driver

    Creator:
    Jiang, William
    Abstract:
    A short-circuit-protected line-driver circuit is particularly adapted for use in a CMOS differential line-driver system, where one line-driver circuit provides a true output signal, and another line-driver circuit provides a complementary false output signal. A short-circuit is sensed by measuring current through a secondary pull-up transistor, and disabling a primary...
    Resource Type:
    Masters Thesis