Search Constraints

Start Over
Filtering by: Publisher Portland State University Remove constraint Publisher: Portland State University Contributor advisor sim Wager, John F. Remove constraint Contributor advisor sim: Wager, John F. Decade 2010-2019 Remove constraint Decade: 2010-2019

Search Results

  • Electronic Conduction Mechanisms in Insulators

    Creator:
    Chiang, Tsung-Han
    Abstract:
    The research presented herein focuses on electrical assessment of oxide thin films as insulators. The current density-electric field (J-E) characteristics of four insulators of dramatically different electrical quality are assessed in terms of their operative electronic conduction mechanisms. Conduction in the two high-quality insulators is dominated by Ohmic conduction and...
    Resource Type:
    Dissertation
    Full Text:
    by Tsung-Han Chiang A DISSERTATION submitted to Oregon State University in partial fulfillment

  • Assessment of High Mobility Oxide Thin-Film Transistors

    Creator:
    Stewart, Kevin A.
    Abstract:
    The trend towards higher resolution, faster refresh rate active-matrix liquid-crystal displays (AMLCDs) as well as the emergence of active-matrix organic light-emitting diode (AMOLED) displays is driving the demand for amorphous oxide semiconductor thin-film transistors (AOS TFTs) with higher mobility. A physics-based model for carrier transport in an amorphous semiconductor is...
    Resource Type:
    Dissertation
    Full Text:
    Oregon State University in partial fulfillment of the requirements for the degree of Doctor of

  • DC/AC Stability of In-Ga-Zn-O Thin-Film Transistors

    Creator:
    Zhou, Fan
    Abstract:
    The electrical stability of amorphous indium-gallium-zinc oxide (a-IGZO) thinfilmtransistors (TFTs) is investigated for flat-panel display applications. Althoughproducts incorporating a-IGZO TFT backplanes are already commercially available,e.g., iMac with 5K retina display, technical challenges need to be addressed for nextgenerationapplications, e.g., active-matrix organic light-emitting diode displays.Device stability is one crucial issue. The...
    Resource Type:
    Dissertation
    Full Text:
    State University in partial fulfillment of the requirements for the degree of

  • Development of Cu-based Thin Films for Optoelectronic Applications

    Creator:
    Angelos, Gregory S.
    Abstract:
    CIGS and CdTe based commercial thin-film solar cells (TFSCs) require an absorber thickness greater than 2 µm and 4 µm, respectively, to adequately absorb the solar spectrum. To efficiently extract photoexcited electrons, these TFSCs require relatively defect-free absorbers with high-minority carrier mobility (> 100 cm2V−1s−1) and long lifetime (> 10...
    Resource Type:
    Dissertation
    Full Text:
    Optoelectronic Applications by Gregory S. Angelos A THESIS submitted to Oregon State University in partial

  • Development of Amorphous Metal Thin Films for Thermal Inkjet Printing and Microelectronics

    Creator:
    McGlone, John M.
    Abstract:
    Due to a lack of grain boundaries, an amorphous metal thin film (AMTF) possesses advantageous mechanical properties and enhanced chemical stability that is potentially useful for thermal inkjet (TIJ) printing applications. The use of an AMTF as a TIJ resistor or cavitation plate could lead to a thinner TIJ cavitation...
    Resource Type:
    Dissertation
    Full Text:
    understand that my dissertation will become part of the permanent collection of Oregon State University

  • Investigation of ultra-thin In-Ga-Zn-O thin-film transistors

    Creator:
    Chiang, Tsung-Han
    Abstract:
    The objective of the work reported herein is to explore the impact of decreasing channel thickness on radio-frequency (RF) sputtered amorphous indium-gallium-zinc oxide (a-IGZO) thin-film transistors (TFTs) electrical performance through the evaluation of drain current versus gate voltage (I[subscript D] − V[subscript G]) transfer curves. For a fixed set of...
    Resource Type:
    Masters Thesis
    Full Text:
    THESIS submitted to Oregon State University in partial fulfillment of the requirements for the degree

  • Al-In-Sn-O thin-film transistors

    Creator:
    Stewart, Kevin A.
    Abstract:
    The aim of the research undertaken for this thesis was to develop a new high-performance amorphous oxide semiconductor (AOS) for use as a channel layer in a thin-film transistor (TFT). AOS TFTs offer higher electron mobility than the established amorphous silicon based technology. A new channel material comprised of aluminum...
    Resource Type:
    Masters Thesis
    Full Text:
    Transistors by Kevin A. Stewart A THESIS submitted to Oregon State University in partial

  • Amorphous metal thin films as a platform for solution processing

    Creator:
    Landau, Nicholas P.
    Abstract:
    The research presented herein represents an effort to combine the ultra-smooth surface of an amorphous metal thin film (AMTF) with a solution-processed dielectric synthesized via prompt inorganic condensation (PIC). Analysis of dielectric film quality is carried out via electrical measurements of metal-insulator-metal (MIM) diodes. Anneals at 500 and 700 °C...
    Resource Type:
    Masters Thesis
    Full Text:
    Processing by Nicholas P. Landau A THESIS submitted to Oregon State University in partial fulfillment

  • Development of high efficiency solar absorbers

    Creator:
    Ravichandran, Ram
    Abstract:
    Current cadmium telluride and copper indium gallium diselenide thin-film solar cells (TFSCs) utilize thick absorbers (2 - 4 μm). For efficient carrier extraction in these TFSCs, the absorber layer requires high carrier mobilities and a long minority carrier lifetime, which necessitates the use of a high purity, defect-free thin film....
    Resource Type:
    Dissertation
    Full Text:
    High Efficiency Solar Absorbers by Ram Ravichandran A THESIS submitted to Oregon State University

  • Thermally-stable amorphous metal thin films

    Creator:
    McGlone, John M.
    Abstract:
    Amorphous metal thin films (AMTFs) are of potential use for metal-insulator-metal (MIM) tunnel diode applications due to their ultra-smooth surfaces, a consequence of their amorphous microstructure. The objective of this thesis is to design a thermally-stable AMTF capable of maintaining MIM tunnel diode performance after a post-deposition anneal in excess...
    Resource Type:
    Masters Thesis
    Full Text:
    . McGlone A THESIS submitted to Oregon State University in partial fulfillment of the requirements for