Skip to Content

Switch language English
- Switch language
- Deutsch
- English
- Español
- Français
- Italiano
- Português do Brasil
- 中文
Login

ScholarsArchive@OSU

Home
About
Help
Contact

Search ScholarsArchive@OSU

Advanced Search

Search Constraints

Start Over

Filtering by: Creator Hancock, James F. Remove constraint Creator: Hancock, James F. Contributor advisor sim Welty, James R. Remove constraint Contributor advisor sim: Welty, James R. Non-Academic Affiliation Oregon State University. Graduate School Remove constraint Non-Academic Affiliation: Oregon State University. Graduate School

« Previous | 1 - 10 of 48 | Next »

Relevance
Title [A-Z]
Title [Z-A]
Date Created ▼
Date Created ▲
Date Uploaded ▼
Date Uploaded ▲

Number of results to display per page

10 per page
20 per page
50 per page
100 per page

View results as:

List Gallery Masonry

Search Results

A numerical solution for heat transfer to non-Newtonian fluids with temperature-dependent viscosity for arbitrary conditions of heat flux and surface temperature

Creator:

Cochrane, G. F. (Glenn Frank)

Resource Type:

Dissertation

Full Text:

encouragement of the author's major advisor Dr. James R. Welty are gratefully acknowledged. His efforts were a
Heat and mass transfer rates associated with the drying of Southern pine and Douglas fir veneer in air and in steam at various temperatures and angles of impingement

Creator:

Laity, Walter William

Abstract:

Southern pine and Douglas fir veneer samples were dried in air under the following conditions: air temperatures were 350, 600, and 750°F; air velocities were 50, 100, and 150 feet per second, and angles of impingement of air against the veneer surfaces were 0°, 45°, and 90°. The resulting drying...

Resource Type:

Masters Thesis

Full Text:

in Air and in Steam at Various Ternpertures ap.d 4ngles of Im Abstract approved: James R. Wlty
Cold trap performance : a general analysis

Creator:

Rothwell, Micheal Olin

Abstract:

A cold trap is a device used to remove certain impurities from a liquid metal by controlled precipitation of such impurities. An investigation of the thermal characteristics of laminar flow in two air-cooled cold traps was made. This investigation showed that the sodium heat transfer rate is a function of...

Resource Type:

Masters Thesis

Full Text:

for Privacy Abstract approved: James R. Wjlty A cold trap is a device used to remove certain
Drying rates of Douglas fir veneer in superheated steam

Creator:

Atherton, George H. (George Harry), 1920-1987

Resource Type:

Masters Thesis

Full Text:

- tures 400 F, 600 F, and 800 F were used. Drying times from an initial moisture content of about 57
Heat generation rates of nonfissionable materials in a nuclear reactor environment

Creator:

Zimmerman, Paul James

Abstract:

Radiation induced heat generation rates of several nonfissionable materials were measured calorimetrically in a nuclear reactor environment. The calorimeter was uniquely designed to allow many materials of grossly different heat generation rates to be measured. heat transfer characteristics of the calorimeter were determined analytically and experimentally. Materials were chosen to...

Resource Type:

Masters Thesis

Full Text:

Rates of Nonfissionable Materials In A Nuclear Reactor Environment by Paul James Zimmerman A THESIS
An analytical model of heat transfer to a horizontal cylinder immersed in a gas fluidized bed

Creator:

Adams, Ronald Lynn

Abstract:

A steady gas convection model of heat transfer to a horizontal cylinder immersed in a gas fluidized bed is presented. Contributions due to flow within attached bubbles as well as the interstitial voids are included. The interstitial flow is approximated as flow within a series of double cusped channels and...

Resource Type:

Dissertation

Full Text:

Abstract approved: James R. Welty/ A steady gas convection model of heat transfer to a horizontal
Heat and mass transfer rates associated with the drying of plywood veneer using superheated steam at various angles of impingement

Creator:

South, Veeder, III

Resource Type:

Masters Thesis

Full Text:

TRANSFER RATES ASSOCIATED WITH THE DRYING OF PLYWOOD VENEER USING SUPERHEATED STEAM AT VARIOJ.IS ANG F
The study of active sites and bubble formation frequency in nucleate boiling heat transfer

Creator:

Aoki, Tadao

Abstract:

The heat-transfer mechanism studied in this experiment was pool boiling from a flat horizontal surface facing upward with the bulk liquid at its saturation temperature. The hot-film anemometer probe was introduced to boiling heat-transfer analysis as a possible device for counting active nucleation sites and for other investigations such as...

Resource Type:

Masters Thesis

Full Text:

appreciation goes to Dr. James R. Welty for his valuable suggestions throughout this project. Also I would
The design, construction and calibration of an instrumented surface for convective heat transfer studies

Creator:

Meyers, Stanley Kent

Abstract:

The purpose of this thesis work has been the design, construction and calibration of an instrumented surface for convective heat transfer studies. The surface is in the form of a flat plate roughly 24 inches wide by 48 inches long. It is made up of 48 individual cells, laminated side-by-side...

Resource Type:

Masters Thesis

Full Text:

STUDIES. Abstract approved: Redacted for Privacy James R. 'Welty The purpose of this thesis work has
An experimental study of natural convection in air between a vertical isothermal flat plate and a parallel insulated flat plate

Creator:

Kim, Sung-Soo

Abstract:

Natural convection heat transfer in air between two vertical plates 38 by 24 inches was investigated in this work with spacings between the plates of 0.625, 1.0 and 1.75 inches. One plate was isothermal and the other adiabatic. To measure the point velocities in the air layer a very thin...

Resource Type:

Masters Thesis

Full Text:

FLAT PLATE AND A PARALLEL ,INSULATED. FLAT PLATE Redacted for privacy James R. Welt Abstract approved

« Previous
Next »
1
2
3
4
5

Limit your search

Academic Affiliation

Mechanical Engineering31
Mechanical, Industrial, and Nuclear Engineering6
Mechanical and Industrial Engineering4
Mechanical and Metallurgical Engineering4
Mechanical and Nuclear Engineering3

Advisor

Welty, James R.48

Commencement Year

Commencement Year range begin – Commencement Year range end

Current results range from 1966 to 2001

View distribution

Committee Member

Davis, Lorin R.3
Adams1
Bodvarsson, Gunnar1
Booster, Dean E.1
Bushnell, Dwight1
more Committee Members »

Creator

Aoki, Tadao2
Hong, Seung Ho2
Adams, Ronald Lynn1
Arib, Fouad1
Atherton, George H. (George Harry), 1920 19871
more Creators »

Date

Date range begin – Date range end

Current results range from 1965 to 2000

View distribution

Decade

2000-20091
1990-199912
1980-19899
1970-197914
1960-196912

Degree Field

Mechanical Engineering39
Mechanical and Industrial Engineering4
Mechanical and Metallurgical Engineering3
Mechanical and Nuclear Engineering2

Degree Level

Master's25
Doctoral23

Degree Name

Master of Science (M.S.)25
Doctor of Philosophy (Ph.D.)23

Language

English [eng]48

Non-Academic Affiliation

Oregon State University. Graduate School[remove]48

Peer Reviewed

No48

Resource Type

Masters Thesis25
Dissertation23

Rights Statement

Copyright Not Evaluated45
In Copyright3

Subject

Heat -- Transmission19
Heat -- Convection8
Fluid dynamics4
Fluidized-bed combustion3
Laminar flow3
more Subjects »

Scholars Archive is a service of Oregon State University Libraries & Press

121 The Valley Library
Corvallis, OR 97331-4501

Contact Us
Services for Persons with Disabilities

Powered by Hyrax 3.6.0

Copyright © 2018 Oregon State University
Licensed under the Apache License, Version 2.0

Core Trust application (pdf)