In order to estimate wind turbine residL2;characteristics
in the presence of atmospheric turbulence, the important atmospheric
sources for the force excitations felt by the wind turbine system
must be identified and characterized. The goal of this research
is to develop the wind turbulence input model for horizontal axis
wind turbines....
Mechanical behavior of Nb-Ti superconducting composites with copper matrices have
been studied experimentally and theoretically.
Experimental work includes extensive measurements of Cu/Nb-Ti composite system.
Techniques for fine fiber testing and composite wire measurement have been developed.
Experimental parameters examined in this research include geometry, hardness, Young's
modulus, Poisson's ratio, yield...
Several standardized courses for Formula SAE (FSAE) testing are introduced and described with sufficient detail to be reproduced by any Formula SAE team. Basic analysis methods for the courses are given as well as explanations of how those analyses could be used. On-car data from the Global Formula Racing (GFR)...
The compressive behavior of continuous fiber composites is not as well
understood as their tensile behavior because research and industrial applications have until
recently focused on the latter. Furthermore, most theoretical and experimental studies on
the compression of composites have examined the case of unidirectional specimens with
fibers along the...
Pure aluminum deformed in torsion (shear) at elevated temperatures reaches
a broad "peak" stress and then undergoes about a 17% decrease in flow stress with
deformation to roughly 1-2 equivalent uniaxial strain. Beyond this strain the flow
stress is approximately constant. The sources for this softening are unclear. The
suggested...
Algorithms for analyzing laser interferometry
signals were developed and adopted to the computer based
processing of small displacement measurements. These
methods, matrix operation approach and fixed parameters
approach, are based on signal phase calculation and are
able to replace complex fringe counting electronic
circuits. The matrix operation provides an approach...
Improvement of manufacturing productivity is dependent on the successful
automation of manufacturing processes, the success of which is based in turn upon
the availability of information which describes the state of manufacturing operations.
Acoustic Emission (AE) signals related to the cutting process and tool wear have
been recently applied to...
The development of modern industries calls for the
robotic manipulators with high speed and accurate tracking
performance. Many authors have paid attention to robust
control of robotic manipulators; however, only few authors
have also considered the control problem of manipulators
with power limitation.
In this dissertation, the robotic manipulator is...
This dissertation investigates by means of computer simulation the potential of a
Band Variable-Inertia Flywheel (BVIF) to store energy for an urban transit bus.
Replacing both a fixed-inertia flywheel (FIF) and a continuously variable transmission
(CVT), the Band Variable-Inertia Flywheel is capable of accelerating a vehicle
from rest to a...