An enhanced swing differential Colpitts VCO (ESDC-VCO) dramatically improves
the swing of a Colpitts VCO by allowing the signal to swing below ground and above the
supply voltage. Fabricated in a 1P8M 0.13 um CMOS process, the ESDC-VCO operates
at 4.9GHz with a 0.475-V supply and consumes 2.7mW. The measured...
An ultra low power crystal oscillator that provides a frequency reference for battery
powered timekeeping applications is presented. An amplitude control circuit is employed to ensure that minimum current is consumed. A subthreshold voltage regulator provides a supply voltage for the oscillator with minimum current consumption. The oscillator and regulator...
A fully integrated CMOS GPS receiver RF front end optimized for low power operation is presented. The system operates with a supply voltage down to 250 mV. A prototype has been fabricated in a 0.13μm CMOS process and includes a low voltage LNA, quadrature oscillators, and quadrature mixers. It exhibits...
The electrical behavior of on-chip interconnects has become a dominant factor in silicon-based high speed, RF, and mixed-signal integrated circuits. In particular, the frequency-dependent loss mechanisms in heavily-doped silicon substrates can have a large influence on the transmission characteristics of on-chip interconnects. To optimize the performance of the integrated circuit,...
Analog-to-Digital Data Converters (ADCs) used in instrumentation and measurements often require high absolute accuracy, including excellent linearity and negligible dc offset. Incremental data converters (IDCs) provide a solution for such measurement applications. Since IDCs are essentially delta-sigma converters with reset operation before each conversion, they retain most of the advantages...
Delay insensitive asynchronous circuitry provides significant advantages with
respect to substrate noise due to localized switching. The differences between the
substrate noise from NULL Convention Logic (NCL) and traditional Clocked
Boolean Logic (CBL) are described and analyzed based on measured results. A test chip fabricated in the TSMC 0.25 um...
With the ever-increasing demand for portable devices used in applications
such as wireless communication, mobile computing, consumer electronics, etc.,
the scaling of the CMOS process to deep submicron dimensions becomes more
important to achieve low-cost, low-power and high-performance digital systems.
However, this downscaling also requires similar shrinking of the supply...
A two-channel data acquisition system for simultaneous detection and discrimination of beta particles and gamma rays has been developed. Each channel measures and analyzes the input pulses resulting from the absorption of radiation in the layers of the detector. The detector is a triple-layer phoswich (phosphor sandwich) scintillation detector followed...
This dissertation investigates the use of a hardware mechanism called Eager Data Transfer (EDT) for achieving the reduction of communication latency for user-level network protocol. To reach the goal, the dissertation addresses the following research issues. First, the development of a communication system performance evaluation tool called Linux/SimOS is presented....
Multiple-input multiple-output (MIMO) communication systems have recently been considered as one of the most significant technology breakthroughs for modern wireless communications, due to the higher spectral efficiency and improved link reliability. The sphere decoding algorithm (SDA) has been widely used for maximum likelihood (ML) detection in MIMO systems. It is...