This thesis proposes a novel technique for the design of pipelined and cyclic ADCs utilizing generalized radix gain stages. Several models have been proposed for the optimization of high performance pipelined ADCs by various researchers. This work builds upon them, using a simple but accurate model to estimate the optimal...
This dissertation focuses on the development of ultra-compact optical devices for free-space modulation. We propose a surface-normal modulator using metallic photonic crystals for free-space optical interconnects. The active control of light intensity is achieved by engineering the Fano resonances in metallic photonic crystals. Both thermo-optic modulation and electro-optic modulation of...
Phase-locked loop (PLL) frequency synthesizers lie at the heart of most radio transceivers. An important objective of the electronics and communications industry is to design high-speed building blocks which dissipate the lowest possible power, and to ac- complish this with the cheapest technology. The dual-modulus prescaler is one of the...
The increased use of mobile wireless devices that we have recently been witnessing, such as smartphones, tablets, e-readers, and WiFi enabled devices in general, is driving an unprecedented increase in the amount of data traffic. This fast market adoption of the wireless technology along with the tremendous success of multimedia...
An enhanced swing differential Colpitts VCO (ESDC-VCO) dramatically improves
the swing of a Colpitts VCO by allowing the signal to swing below ground and above the
supply voltage. Fabricated in a 1P8M 0.13 um CMOS process, the ESDC-VCO operates
at 4.9GHz with a 0.475-V supply and consumes 2.7mW. The measured...
The complexity of designing and testing today's system on chip (SOC) is increasing due to greater integrated circuit (IC) density and higher IO and memory frequencies. SOCs for the mobile phone and tablet market have the unique challenge of short product development windows, at times less than six months, and...
The demand for portable electronic systems and the continued
down-scaling of device dimensions resulted in rapid improvement in
the performance of integrated systems. Several low-voltage design
techniques have been proposed to operate analog circuits with sub-1V
supply. However, these techniques require higher power consumption
to achieve large dynamic range while...
Massive MIMO is a promising technique for future 5G communications due to its high spectrum and energy efficiency. To realize its potential performance gain, accurate channel state information at transmitter side (CSIT) is essential. Frequency division duplex (FDD) is widely employed by the most cellular systems today. However, it requires...
This dissertation presents a low-power high-resolution delta-sigma ADC. Two new architectural design techniques are proposed to reduce the power dissipation of the ADC. Compared to the conventional active adder, the direct charge transfer (DCT) adder greatly saves power by keeping the feedback factor of the active adder unity. However, the...
Triangulateration uses geometric distance to estimate the location of user by employing techniques like received signal strength (RSS), time-of-arrival (TOA), time-difference-of-arrival (TDOA) and image processing.
Radio frequency (RF) signal positioning using TOA or TDOA techniques generally requires timing synchronization of the anchors and/or the anchors and targets. If the desired...