Search Constraints

Start Over
Filtering by: Creator Gerdeman, B. S. Remove constraint Creator: Gerdeman, B. S. Committee Member Liu, Huaping Remove constraint Committee Member: Liu, Huaping

Search Results

  • Design techniques for low-power multi-GS/s analog-to-digital converters

    Creator:
    Jiang, Tao
    Abstract:
    Ultra-high-speed (>10GS/s), medium-resolution (5~6bit), low-power (<50mW) analog-to-digital converter can find it application in the areas of digital oscilloscopes and next-generation serial link receivers. There are several challenges to enable a successful design, however. First, the time-interleaved architecture is required in order to achieve over 10GS/s sampling rate, with the trade-off...
    Resource Type:
    Dissertation
    Full Text:
    previous work of sub-ADC, a 12-GS/s 5-b 50-mW ADC is designed in 40nm CMOS with 8 time-interleaved

  • Analysis and design on low-power multi-Gb/s serial links

    Creator:
    Hu, Kangmin
    Abstract:
    High speed serial links are critical components for addressing the growing demand for I/O bandwidth in next-generation computing applications, such as many-core systems, backplane and optical data communications. Due to continued process scaling and circuit innovations, today's CMOS serial link transceivers can achieve tens of Gb/s per pin. However, most...
    Resource Type:
    Dissertation
    Full Text:
    ) Jitter impulse response and (b) jitter transfer function of a 40cm PCB trace at 20-Gb/s

  • Ultra-low power receivers for wireless sensor networks

    Creator:
    Ayers, James S.
    Abstract:
    In wireless sensor network applications, low-power operation of the wireless receiver is critical. To address this need an ultra-low power Binary Frequency Shift Keying (BFSK) receiver using the super-regenerative architecture is developed. A prototype receiver is built and tested for operation in the 900 MHz ISM band. Lab measurements show...
    Resource Type:
    Dissertation
    Full Text:
    Fmin,CG,S−B = 1+ γ α (2.4) where γ is the channel noise coefficient (2 for short-channel devices) and

  • RF and Millimeter-wave Techniques to Improve Scalability and Efficiency of Digital Beamforming Arrays

    Creator:
    Johnson, Manoj
    Abstract:
    Spectrum overcrowding, ever increasing demand for high data rate and increased mobility requirements are three major challenges 5G-technology is trying to address. In this thesis I start with a RF front-end technique that deals with blocker interference arising from spectrum overcrowding both across frequency bands and within the same frequency...
    Resource Type:
    Dissertation
    Full Text:
    . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 48 3.21 (a) 28 GHz input matching on PCB using L-C-L network with wirebonds, (b) Measured input s

  • Modeling and analysis of spur structure of digital-to-time conversion based frequency synthesizers

    Creator:
    Talwalkar, Sumit A.
    Abstract:
    Frequency synthesizers are critical components of all communication systems. This thesis considers the issue of undesirable frequency spurs of a relatively recent type of frequency synthesis architecture called digital-to-time conversion (DTC). The DTC-based frequency synthesis architecture has important performance benefits over older frequency synthesizers, such as fast frequency switching, large...
    Resource Type:
    Dissertation
    Full Text:
    : S. Lawrence Marple, Jr. Frequency synthesizers are critical components of all communication

  • Multi-dimensional parametric estimation: two-dimensional sharpening by predictive bandwidth extrapolation and fast algorithms for three dimensional autoregressive estimation

    Creator:
    Liew, Ji Seok
    Abstract:
    Achieving sharpened (enhanced detail) features of a multi-dimensional data source using the linear prediction (LP) bandwidth extrapolation (BWE) technique in the transform domain is the main objective of this research. The evolution of sensor technology has provided acquisition scenarios in which the data format is inherently multi-dimensional, including hyperspectral imaging...
    Resource Type:
    Dissertation
    Full Text:
    . ..................................................................................40 Figure 20. S-band SAR image with analysis center azimuth in degrees (a),(b) radar image of

  • Kinematic and cyclostationary parameter estimation for co-channel emitter location applications

    Creator:
    Ohm, David R.
    Abstract:
    The problem of locating a signal source, or an emitter, has many civilian and military applications, such as communication regulations enforcement, military reconnaissance, and search-and-rescue operations. Many of the most widely used emitter location methods rely on the accurate and robust estimation of the differential time delay, or time-difference-of-arrival (TDOA),...
    Resource Type:
    Dissertation
    Full Text:
    Abstract approved: S. Lawrence Marple Jr. The problem of locating a signal source, or an emitter, has

  • Noise and Blocker Cancellation Techniques for Power and Area Efficient Wireless Receivers

    Creator:
    Pourbagheri, Saeed
    Abstract:
    The design of mobile wireless devices has always focused on reducing power, area, and cost. This dissertation proposes two techniques that are leveraged to save power and area and therefore cost. The first techniques reduces the noise in the receiver and results in a relaxed power requirement. The second technique...
    Resource Type:
    Dissertation
    Full Text:
    ) conventional architecture, and (b) proposed architecture. ()dt bit + - Vref s,n Balun ()dt bit s,n1 s

  • Comparison and impact of substrate noise due to clocked and clockless circuitry

    Creator:
    Le, Jim K.
    Abstract:
    Delay insensitive asynchronous circuitry provides significant advantages with respect to substrate noise due to localized switching. The differences between the substrate noise from NULL Convention Logic (NCL) and traditional Clocked Boolean Logic (CBL) are described and analyzed based on measured results. A test chip fabricated in the TSMC 0.25 um...
    Resource Type:
    Masters Thesis
    Full Text:
    s Time N u m b er o f T ra n si ti o n s Figure 1.1: Idealized gate switching

  • An enhanced swing differential Colpitts CMOS VCO for low-voltage operation

    Creator:
    Farahbakhshian, Farhad
    Abstract:
    An enhanced swing differential Colpitts VCO (ESDC-VCO) dramatically improves the swing of a Colpitts VCO by allowing the signal to swing below ground and above the supply voltage. Fabricated in a 1P8M 0.13 um CMOS process, the ESDC-VCO operates at 4.9GHz with a 0.475-V supply and consumes 2.7mW. The measured...
    Resource Type:
    Masters Thesis
    Full Text:
    . Karaler, S. Li, B. Otis, M. Sheets, and T. Tuan “PicoRadios for wireless sensor networks: the next