In Radio Frequency Integrated Circuits (RFIC) or high frequency digital
ICs, there is a demand to probe the internal nodes for testing. The ultra low
capacitance RFIC probe presented in his work is a flexible tool for these
applications. The probe utilizes the coupling between a tungsten needle and the...
This thesis presents a channelized digital receiver design for UWB sytems in a multipath indoor environment. The UWB technology has been used for commercial and military purposes due to a number of advantages such as low-power consumption, noise-like and carrier free. The energy of UWB signal is spread over a...
Massive MIMO is a promising technique for future 5G communications due to its high spectrum and energy efficiency. To realize its potential performance gain, accurate channel state information at transmitter side (CSIT) is essential. Frequency division duplex (FDD) is widely employed by the most cellular systems today. However, it requires...
In wireless communication, channel state information (CSI) is essential for data detection. Fast fading coefficients estimation is important in order to acquire accurate CSI. Kalman filters (KF) are widely used for real time parameter estimation and can be used to estimate the fast fading coefficients of a mobile communication channel....
Estimating the carrier frequency from a modulated waveform is one of the most important functions of a coherent signal receiver. Good performance and low bit error rates are obtained by coherent demodulation. Therefore, exact knowledge of the received signal carrier frequency is critical for communication systems. Also due to the...
The decrease of switching times accompanied by the corresponding increase of
clock speeds and data rates, contributes to improve the overall system
computational performance. At the same time, they also affect wireless
communications due to an increment in the emissions of electromagnetic
radiation on the radio bands.
In this dissertation...
In networked control systems (NCS) information or packets usually flow from a
sensor or a set of sensors to a remotely located controller. Then the controller
processes the received information and sends a series of control commands to the
actuators through a communication network which could be either wireless or...
As the number of mobile devices accessing large-scale WLANs such as campus
and metropolitan area networks increases, the need for load balancing among the
cells becomes crucial. In addition, the network must also support some minimum
handoff tolerance defined by an application.
A number of load balancing techniques have been...
In wireless sensor network applications, low-power operation of the wireless receiver is critical. To address this need an ultra-low power Binary Frequency Shift Keying (BFSK) receiver using the super-regenerative architecture is developed.
A prototype receiver is built and tested for operation in the 900 MHz ISM band. Lab measurements show...
A fully integrated CMOS GPS receiver RF front end optimized for low power operation is presented. The system operates with a supply voltage down to 250 mV. A prototype has been fabricated in a 0.13μm CMOS process and includes a low voltage LNA, quadrature oscillators, and quadrature mixers. It exhibits...