In wireless communication, channel state information (CSI) is essential for data detection. Fast fading coefficients estimation is important in order to acquire accurate CSI. Kalman filters (KF) are widely used for real time parameter estimation and can be used to estimate the fast fading coefficients of a mobile communication channel....
The ability to accurately locate people and objects indoors will enable opportunities for control and automation of indoor environments. Current indoor localization solutions require dedicated hardware which must be custom tailored to each application. There are large technological, societal, and economic benefits in developing a more general purpose system that...
This work focusses on the modeling and the development of efficient coupled simulation techniques for MEMS based RF oscillators. High-level models for MEMS based varactors have been discussed and their accuracy issues are identified, based on comparisons with numerical simulations. A faster simulation approach based on the time-domain shooting method...
There is a large and growing market for portable consumer audio products
with very small size. As the size of these products is reduced, the area occupied
by batteries becomes significant and hence limits the number of batteries to one.
In order to build such small products, high levels of...
Traditionally linear actuator applications are addressed by the use of hydraulic systems. The high maintenance cost and poor reliability will always be the most critical problem in the real applications. Benefited from both the high mechanical advantage of the roll screw and the simple structure of the switched reluctance motor,...
The exponential rate of advances in modern communication devices in the last several years have brought us higher levels of functionality and performance as well as reductions in physical size and power consumption. To continue this rate of advancement, next generation systems require wider bandwidth and higher resolution ADCs. Additionally,...
The demand for portable electronic systems and the continued
down-scaling of device dimensions resulted in rapid improvement in
the performance of integrated systems. Several low-voltage design
techniques have been proposed to operate analog circuits with sub-1V
supply. However, these techniques require higher power consumption
to achieve large dynamic range while...
For the past half century, CMOS process scaling has followed Moore's law, approximately doubling transistor density every 18 months. While locally routed wires have generally scaled with transistor size, longer wires have scaled at a slower rate and in some cases have grown larger as chip size and complexity have...
This thesis presents two new approaches for the broadband, time-domain modeling of lossy transmission lines. Each approach is based on an alternative derivation of delay extraction in order to separate the line's linear phase from its
attenuation and dispersion. Augmentation networks represent the derived attenuation networks as rational function approximations....
In networked control systems (NCS) information or packets usually flow from a
sensor or a set of sensors to a remotely located controller. Then the controller
processes the received information and sends a series of control commands to the
actuators through a communication network which could be either wireless or...