We report an inverse relationship between measurable porosity values and reversible capacity from sucrose-derived hard carbon as an anode for sodium-ion batteries (SIBs). Materials with low measureable pore volumes and surface areas obtained through N₂ sorption yield higher reversible capacities. Conversely, increasing measurable porosity and specific surface area leads to...
Porous silicon prepared by low-cost and scalable magnesiothermic reactions is a promising anode material for Li-ion batteries; yet, retaining good cycling stability for such materials in electrodes of practical loading remains a challenge. Here, we engineered the nanoporous silicon from a modified magnesiothermic reaction by controlled surface oxidization forming a...
Full Text:
electrolyte
interphase (SEI) and continuous consumption of electrolyte [1–
4]. As a result, Si electrodes
Na-ion batteries are emerging as one of the most promising energy storage technologies, particularly for grid-level applications. Among anode candidate materials, hard carbon is very attractive due to its high capacity and low cost. However, hard carbon anodes often suffer a low first-cycle Coulombic efficiency and fast capacity fading. In...
Full Text:
formation of solid
electrolyte interphase (SEI) layer on the large surface area.43,44 This can be a
We introduce a novel ambient hydrolysis deposition (AHD) methodology that, for the first time, employs sequential water adsorption followed by a hydrolysis reaction to infiltrate tiny SnO2₂ particles inside nanopores of mesoporous carbon in a conformal and controllable manner. The empty space in the SnO2₂/C composites can be adjusted by...
A low-voltage plateau at ∼0.3 V is discovered during the deep sodiation of Na₃V₂(PO₄)₃ by combined computational and experimental studies. This new low-voltage plateau doubles the sodiation capacity of Na₃V₂(PO₄)₃, thus turning it into a promising anode for Na-ion batteries.
Full Text:
(SEI). Note that no corresponding anodic peak is observed. 30
Subsequent CV curves overlap well
We demonstrate a novel synthetic route to fabricate a one-dimensional
peapod-like Sb@C structure with disperse Sb
submicron-particles encapsulated in carbon submicron-tubes.
The synthetic route may well serve as a general methodology
for fabricating carbon/metallic fine structures by thermally
reducing their carbon-coated metal oxide composites.
Air-cathode fabrication is currently a key factor that hinders the scaling up of microbial fuel cell (MFC) technology. A new type of cathode material that contains porous polyethylene (PE) sheet and a blended activated carbon (AC) and highly conductive carbon back (CB) layer was developed for the first time. The...
Magnesiothermic reduction can directly convert SiO₂ into Si nanostructures. Despite intense efforts, efficient fabrication of highly nanoporous silicon by Mg still remains a significant challenge due to the exothermic reaction nature. By employing table salt (NaCl) as a heat scavenger for the magnesiothermic reduction, we demonstrate an effective route to...