Index Catalog // ScholarsArchive@OSU

Pure torsion of a slotted channel member

Creator:: Benedetti, Gerald Andrew
Resource Type:: Masters Thesis
Full Text:: . Numerical results have been obtained in the past by applica tion of Prandtl1 s membrane analogy, thereby

The effect of small amounts of magnesium on the superplastic behavior of an aluminum-zinc alloy

Creator:: Abbott, Vaughn William
Abstract:: The base Al-Zn superplastic alloy was investigated at 250°C to determine the effect of small amounts of magnesium on mechanical properties. Six alloys of nominal composition 0.00, 0.10, 0.25, 0.50, 0.75, and 1.00 weight percent magnesium, constant 78 weight percent zinc, and variable 21 to 22 weight percent aluminum were...
Resource Type:: Masters Thesis
Full Text:: examine the past and present research findings in the growing field of superplasticity and apply these

An investigation of the removal of ozone by activated charcoal

Creator:: Liffick, Glenn Lonngren
Abstract:: The removal of ozone from an air stream by activated-cocoanut charcoal was investigated from the literature and experimentally. The experimental investigation showed that activated-cocoanut charcoal can be used to remove concentrations of ozone less than 1.0 ppm with high efficiencies. The mechanism of the ozone removal appeared to be a...
Resource Type:: Masters Thesis
Full Text:: An investigation of the removal of ozone by activated

The effects of stress and temperature on the creep of aluminum alloy conductor wire

Creator:: Riesland, Edward Ernest
Resource Type:: Masters Thesis
Full Text:: . The theory makes use of the con~ oept of "units of flow", structures in a body whose motion past

Effect of initial conditions on the convergence rate of the energy equation in Couette flow

Creator:: Seddigh, Foad
Abstract:: Computers are very efficient in handling the problems which deal with iteration. Numerical treatment of the unsteady energy equation is one sort of iteration. The convergence of the unsteady film coefficient, in two dimensional space, to its steady state value has been deduced by comparison of the results of the...
Resource Type:: Masters Thesis
Full Text:: Effect of initial conditions on the convergence rate of

An experimental study of the acoustical characteristics of dampers in air conditioning systems

Creator:: Yun, Kyung Woo
Abstract:: The noise problem in air conditioning systems is receiving ever increasing attention because of the importance of noise on a comfortable human environment. Some work has been done on the solutions to the noise problem by an investigation of a few system elements. The acourstical characteristics of dampers become more...
Resource Type:: Masters Thesis
Full Text:: An experimental study of the acoustical characteristics of

Effects of selected minor alloying additions on the structure deformation characteristics of beryllium

Creator:: Dooley, George Joseph, III
Abstract:: Solid solution alloying was employed in an attempt to produce some relatively ductile form of beryllium. If the c/a ratio could be significantly altered, it was felt new or different slip systems could be activated. The following elements were selected on the basis of atomic size, melting point, crystal structure...
Resource Type:: Dissertation
Full Text:: Effects of selected minor alloying additions on the

The conversion of solar radiation to heat energy using a trough-type parabolic mirror

Creator:: Mackie, Keith Leroy
Resource Type:: Masters Thesis
Full Text:: The conversion of solar radiation to heat energy using a

The effect of entrance configuration on local heat transfer coefficients in subsonic diffusers

Creator:: Stoffel, Edward Oswald
Abstract:: The effects of round, square, and reentrant entrances on flow regimes and local heat transfer coefficients were determined using a symmetrical, plane-wall two-dimensional, subsonic air diffuser with one of the diverging walls heated and maintained isothermal. Flow and heat transfer studies were made at total divergence angles ranging from 0...
Resource Type:: Masters Thesis
Full Text:: be much like jet flow past a flat plate, it was assumed that the var- iation of the maximum free

The use of a Stirling hot-air engine in converting solar energy to mechanical power

Creator:: Boehme, Martin Leon
Resource Type:: Masters Thesis
Full Text:: pertormed with the end of the cylinder submerged approximately 1/2, 1, and l-1/2 in. past the mirror's

ScholarsArchive@OSU

Pure torsion of a slotted channel member

The effect of small amounts of magnesium on the superplastic behavior of an aluminum-zinc alloy

An investigation of the removal of ozone by activated charcoal

The effects of stress and temperature on the creep of aluminum alloy conductor wire

Effect of initial conditions on the convergence rate of the energy equation in Couette flow

An experimental study of the acoustical characteristics of dampers in air conditioning systems

Effects of selected minor alloying additions on the structure deformation characteristics of beryllium

The conversion of solar radiation to heat energy using a trough-type parabolic mirror

The effect of entrance configuration on local heat transfer coefficients in subsonic diffusers

The use of a Stirling hot-air engine in converting solar energy to mechanical power

Limit your search

Academic Affiliation

Advisor

Commencement Year

Committee Member

Creator

Date

Decade

Degree Field

Degree Level

Degree Name

Language

Non-Academic Affiliation

Peer Reviewed

Resource Type

Rights Statement

Subject

Search Constraints

Search Results

Limit your search