Microscale continuous thin films or patterned conductive structures find applications in thin film electronics, energy generation and functional sensor systems. An emerging alternative to conventional vacuum based deposition of such structures is the additive deposition and sintering of conductive nanoparticles, to enable low temperature, low- cost and low energy fabrication....
Polylactic acid (PLA), a renewable material, is used widely in a variety of commercial and specialty applications. However, certain limitations such as high temperature stability and brittleness limit its applicability. This problem is addressed by reinforcing PLA with a variety of materials but the process gives rise to different issues...
The objective of the work reported herein is to explore the impact of decreasing channel thickness on radio-frequency (RF) sputtered amorphous indium-gallium-zinc oxide (a-IGZO) thin-film transistors (TFTs) electrical performance through the evaluation of drain current versus gate voltage (I[subscript D] − V[subscript G]) transfer curves. For a fixed set of...
Current cadmium telluride and copper indium gallium diselenide thin-film solar cells
(TFSCs) utilize thick absorbers (2 - 4 μm). For efficient carrier extraction in these TFSCs,
the absorber layer requires high carrier mobilities and a long minority carrier lifetime, which
necessitates the use of a high purity, defect-free thin film....
A scalable synthesis of the "flat" tridecameric inorganic cluster [Al₁₃(μ₃-OH)₆(μ-OH)₁₈(H₂O)₂₄]¹⁵⁺ has been realized by treating an aqueous aluminum nitrate solution with zinc-metal powder at room temperature. Single crystals and polycrystalline samples are readily obtained in yields exceeding 55% relative to the starting reagent Al(NO₃)₃. Products have been characterized by X-ray...
Piezoelectric materials have been widely used in electromechanical actuators, sensors, and ultrasonic transducers. Among these materials, lead zirconate titanate Pb(Zr[subscript 1‐x]Ti[subscript x])O₃ (PZT) has been primarily investigated due to its excellent piezoelectric properties. However, environmental concerns due to the toxicity of PbO have led to investigations into alternative materials systems....
Indium-gallium-zinc oxide (IGZO) and zinc-tin oxide (ZTO) are investigated for thin-film transistor (TFT) applications. Negative bias illumination stress (NBIS) is employed for electrical stability assessment. Unpassivated IGZO and ZTO TFTs suffer from severe NBIS instabilities. Zinc-tin-silicon oxide is found to be an effective passivation layer for IGZO and ZTO TFTs,...
The continuous microreactor-assisted solution deposition (MASD) process was used for the deposition of CdS thin films on fluorine-doped tin oxide (FTO) glass. The MASD system, including a T-junction micromixer and a microchannel heat exchanger is capable of isolating the homogeneous particle precipitation from the heterogeneous surface reaction. The results show...
Nanolaminate dielectrics combine two or more insulating materials in a many-layered film. These structures can be made to significantly outperform films composed of a single one of their constituent materials by adjusting the composition ratio, arrangement, and size of the component layers. In this work, atomic layer deposition (ALD) is...
Amorphous oxide semiconductor (AOS) thin-film transistors (TFTs) constitute the central theme of this thesis. Within this theme, three primary areas of focus are pursued.
The first focus is the realization of a transparent three-stage ring oscillator with buffered output and an output frequency in the megahertz range. This leads to...